« previous next »
Pages: 1 ... 6 7 [8] 9 10 ... 64

Author Topic: What did you do to your DownTown today?  (Read 143427 times)

de dee

  • Hero Member
  • *****
  • Posts: 2055
  • 2011 300i downtown 82,265 KM.
    • View Profile
Re: What did you do to your DownTown today?
« Reply #105 on: December 28, 2014, 05:45:19 AM »
  I road around the street to warm up the engine, then I changed the oil, put in rotella T 6  0/40,  I was checking the level and I twitched as I was putting the dip stick in and the end broke off,. and it slide in to the oil fill hole, does any one know how to remove it, with out a complete tear down,.  mean while back to the drawing board for me ( service manual,)
Logged

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: What did you do to your DownTown today?
« Reply #106 on: December 28, 2014, 09:07:45 AM »
Wow... That's gonna be tough to get out. It actually won't be an issue to simply leave it in there.

The oil pump is about 2 1/2" off the bottom of the case, and the plastic will not float in there. I'm sure it will find a cozy corner, and settle in for the long run.

Happy New Year Dee!
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

de dee

  • Hero Member
  • *****
  • Posts: 2055
  • 2011 300i downtown 82,265 KM.
    • View Profile
Re: What did you do to your DownTown today?
« Reply #107 on: December 29, 2014, 08:02:10 AM »
   well I went to Canadian tire and bought some dino oil,. put it in front of the fire place to warm up, 
and tried to flush out the piece of plastic,. but no luck so Ill take your advise Z. and leave it there,. at the same time I checked out my modded dr. pulley sliders 21/18  14 gram , cut down to 21/12   14 gram,.  they looked like new no wear, and it sure lowered my RPM. at high way speeds,. and the inner face variator is modded too,  I extended the slides where the sliders sit,. that counted for half of the lowered RPM.  wish I could send some Pic.s  brought up with pony express


,.








Logged

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: What did you do to your DownTown today?
« Reply #108 on: December 29, 2014, 12:04:04 PM »
I'm still working on a set of 4 yo Dr. Pulleys. Their life span alone makes them MUCH more economical than any roller out there.

I'm a fan for life.
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

kneeslider

  • Hero Member
  • *****
  • Posts: 547
    • View Profile
Re: What did you do to your DownTown today?
« Reply #109 on: January 02, 2015, 04:28:55 AM »
Got the CVT serviced and replaced the main belt, 12000kms.

The scoot feel so much smoother now.
Logged
2019 Yamaha X-Max 250

sklnzl

  • Jr. Member
  • **
  • Posts: 93
    • View Profile
Re: What did you do to your DownTown today?
« Reply #110 on: February 03, 2015, 03:27:09 PM »
Removed  my oem exhaust and replaced it with a Leo Vince .got it from Ebay for 280 euro ,not yet tried it on the road,but the sound is definitely louder but not "grotesque ".
Logged

sklnzl

  • Jr. Member
  • **
  • Posts: 93
    • View Profile
Re: What did you do to your DownTown today?
« Reply #111 on: February 03, 2015, 03:29:32 PM »
Here is how it looks now ,definitely a lot better looking !
Logged

AMAC1680

  • Hero Member
  • *****
  • Posts: 1076
  • Outdoorsman, Advocate, Paraplegic
    • View Profile
    • SEGS4VETS
Re: What did you do to your DownTown today?
« Reply #112 on: February 03, 2015, 04:32:38 PM »
Quote from: sklnzl on February 03, 2015, 03:29:32 PM
Here is how it looks now ,definitely a lot better looking !

Very nice.
I put an arrow on my SYM and have gone back and forth about a pipe change on the Downtown. Any difference in the performance ? I've found little difference with pipes and 4t motors.

Be Big,
AMAC
Logged
www.SEGS4VETS.org
2017 Lance Cali Classic 200i
2013 SYM RV200
2013 Kymco Downtown 300
2010 Lance Cali Classic-sold
1973 VW Dune Buggy
1974 VW Meyers Manx

kneeslider

  • Hero Member
  • *****
  • Posts: 547
    • View Profile
Re: What did you do to your DownTown today?
« Reply #113 on: February 05, 2015, 12:43:25 AM »
The odo clicked 13,000kms last night.
Logged
2019 Yamaha X-Max 250

kneeslider

  • Hero Member
  • *****
  • Posts: 547
    • View Profile
Re: What did you do to your DownTown today?
« Reply #114 on: February 10, 2015, 02:40:21 AM »
Purchased online my new front brake pads.

Replacing the Goldfren AD to Goldfren S33.
Logged
2019 Yamaha X-Max 250

donjack

  • Full Member
  • ***
  • Posts: 193
    • View Profile
Re: What did you do to your DownTown today?
« Reply #115 on: February 10, 2015, 09:38:02 AM »
Ordered a new front tyre, Dunlop scootsmart. 6.6k miles on the original maxxis. Very good  :)
Logged
Why Ride 1 Mile When 10 Will Do!!

Stig / Major Tom

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 14187
  • Rural Ohio
    • View Profile
Re: What did you do to your DownTown today?
« Reply #116 on: February 11, 2015, 01:05:22 AM »
Quote from: donjack on February 10, 2015, 09:38:02 AM
Ordered a new front tyre, Dunlop scootsmart. 6.6k miles on the original maxxis. Very good  :)
The Scoot smart is what is OEM on the Honda Forza. Seems like a good tire......but is a very, very, very rare size here in the States. Most folks are going to a bigger City Grip when time to change as nothing else is avail. - unless you want to order thru the Honda dealer,,, and wait....
Stig
Logged
Boston Strong
Rural Ohio

And, I'm feeling a little peculiar.

kneeslider

  • Hero Member
  • *****
  • Posts: 547
    • View Profile
Re: What did you do to your DownTown today?
« Reply #117 on: February 11, 2015, 02:14:28 AM »
For Malaysia, the tire sizes on the DT is also a rare range.  So far i think we only have the Michelin Pilot Pure SC and Pirelli Diablos.

Every single DT i have seen that has it's tires changed are on the Pilot Pure SC.

After 4000kms on them, I do not like them very much. Tire choice are very subjective so this is based purely on my own reviews.  The PP SC i find lacking in feel and feedback. They do not feed me with info on the grip level of the road surface, nor the 'feel' of being planted at lean. For normal highway commute, I guess they are great in that genre, no tramlining, wear is good.

I have Michelin Pilot Power 3 on my Ducati 848, and those were fantastic, way better than the Bridgestone BT-016 Pro there they replaced. So I guess the tech behind the tires for superbikes isn't really percolated to scooter tires, even thought the marketing for the Pilot Pure SC claims it does.
Logged
2019 Yamaha X-Max 250

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: What did you do to your DownTown today?
« Reply #118 on: February 11, 2015, 03:31:16 AM »
The big difference is in the Radial vs Bias ply (bike vs scooter).
There are no radials in 12" so I'm stuck with what we get.
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

kneeslider

  • Hero Member
  • *****
  • Posts: 547
    • View Profile
Re: What did you do to your DownTown today?
« Reply #119 on: February 13, 2015, 03:07:21 AM »
Some of the Pilot Pure SC are radial but in selected sizes. not sure what the ones for the DT are ply or radial.

Check out the icons in the characteristics:  http://motorcycle.michelinman.com/tires/michelin-power-pure-sc-radial

To add to my review, the tires are not progressive in the wet, meaning, when they break traction, it's immediate, there is no warming.
« Last Edit: February 13, 2015, 03:10:08 AM by kneeslider »
Logged
2019 Yamaha X-Max 250

An Error Has Occurred!

Call to undefined function split()
Back