Watchu Smokin' Slinger...
The smaller screw is the idle mix screw. The larger controls the slide stop, or Idle speed. Since yours is on the reed side it is a FUEL control screw. As you have it 5 out it shows your Pilot jet is too small. That will cause the rest to run lean.
Go up on the pilot, and try to get the mix screw to 2 1/2 turns. The rest will fall in line.
I blew the drive trying to hit 75 on a long straight along the coast. I got 74 in a tuck, and when I let off the drive never closed. Sort of stays in High gear all the time now. I'll have to ride it in to the shop , and fix it during the rest of the stuff I have to do. This was to show a buyer too. He SAYS he will take it once I replace the drive. (I wouldn't let HIM test it wide open) so I had them clock me on Hwy 98. I HOPE This is the last of it! New Ape here I come...
