Drive collar

[DryFly]

2007Kymco People 250 with 18000 km
I’ve taken the variator out and am going to replace the rollers with some DR Pully sliders. When I pulled the variator off the spindle I notice a very small amount of slop where the collar fits in the bushing, I.e. I can wiggle the collar a wee bit. Should there be any slop at all, or is this supposed to be a snug fit?

[Ruffus]

Radial (up/down, left/right) nearly no play (few 1/100 of a mm) .
But: more important the condition of the collar
Any pittings or flaked off chrome?
If not, its normal wear and tear. Bit (very little)  of copper grease or ceramic paste on it and all's well.