Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Berzerker1965

Pages: 1 2 [3] 4
31
Like 50 2T / Re: missing bolt
« on: July 03, 2014, 04:04:51 PM »
Must be aliens!!!!

32
Like 50 2T / Re: missing bolt
« on: July 02, 2014, 05:37:25 PM »
Same bolt was missing from my Honda.

33
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: July 01, 2014, 05:40:26 PM »
Still playing phone tag with SPI. Will keep trying. Looking forward to ordering my parts.

Thanks for the information on the manual. Should come in real handy.
Wil keep you guys updated.

At lunch now. Gotta go.

34
Like 50 2T / Re: missing bolt
« on: June 30, 2014, 04:41:40 AM »
Here is the picture

35
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 30, 2014, 04:39:22 AM »
Thanks again B& L.
 Put a block under the left leg of the stand and was able to get most of the oil in.
Only  small amount of oil was left in the beaker. Is it OK if the oil is a tiny bit short?

36
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 29, 2014, 11:28:39 PM »
Thanks, the conversion is right, maybe I should put a small block under the left leg of the stand. My patio is probably on a slight angle for drainage.

I just don't want to force it in and over fill it.

37
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 29, 2014, 11:06:55 PM »
Used conversation .12 liter = 4 oz.

38
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 29, 2014, 11:04:20 PM »
The reason for taking the scooter panels off is as follows.

1) I'm doing the 200 mile maintenance checklist, checking the plug etc...
2) Just want to take a good look at the engine an carb.

I drained the gear oil. Let drain for 5 minutes after it stopped dripping.
Am now using a syringe to fill it up. While filling it up some drops were coming out of the
Fill hole enough for me to put the brakes under it to catch it and 're-inject with the syringe I'm using.
Is this normal or am I filling it up too much?

39
Like 50 2T / Re: missing bolt
« on: June 28, 2014, 11:00:36 PM »
Thanks, Zombie!

40
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 28, 2014, 10:58:55 PM »
Damn my Honda CH80 was 1 screw in the back and 1 bolt up front and the panels just popped off.

Anyway, Becca, is calling gotta go. I will tackle this in the morning. Thanks!

41
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 28, 2014, 08:23:14 PM »
Also I'm having trouble getting to the brake master cylinder to fill up the brake fluid.

42
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 28, 2014, 08:19:38 PM »
How do you remove the side panels? Is it by taking out the two large screws? Then what? Remove the floor panel and the rear mud flap? I just don't want to force anything.

43
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 28, 2014, 07:51:26 PM »
I started a new topic by mistake.
I found the maintenance checklist in my manual. I bought gear oil and a syringe. I adjusted the rear brakes the 1st day. I also spotted the front brake fluid is low. My conversation equation says .12l = 4oz. I also spotted a missing bolt hole behind the air filter box. Should I be concerned? I tried to upload a photo file but the file is too large.

44
Like 50 2T / missing bolt
« on: June 28, 2014, 07:23:21 PM »
Found checklist in the scooter manual, I'm an idiot. I bought gear oil and a syringe. My conversation equation says .12 l = 4 oz. I also spotted a missing bolt hole behind the air filter box. Took. a photo but can't uplod the file is too large. Should I be concerned?

45
Like 50 2T / Re: Just bought a new 2013 Like 50
« on: June 28, 2014, 03:32:36 PM »
I hit 200 miles and I want to do 200 mile maintenance  check up. I called the dealership and their scooter mechanic was out. I read the thread that says if I keep a good record, i can do it myself. Anyone know what the checklist is?

Pages: 1 2 [3] 4