Scooters - 125 to 300 > People GT 300i
Tail Light Bulb Access
(1/1)
Dav:
Sooo...my brake and tail light weren't working.
The manual says to remove the seat bucket, the seat, the rack, the bodywork etc etc. I tried that but you still can't reach the bulb.
I was sure a company like Kymco wouldn't make you go through all that just for a bulb so I took another look today and viola! Theres a wee inspection hatch on the wheel arch under where the pillion would sit. A couple of push pin coonnectors and the cover has a couple of tabs....easy peasy.
Iahawk:
that's refreshing to see! My S200 required full seat tub plastics removal for a simple rear bulb change.
Stig / Major Tom:
Excellent post!
Yeah, the LIKE200i has the same plastic hatch....behind which are the brake, running and turn signal bulbs. Lay on back. Look up under rear fender.
Stig
Neil955i:
Mental note, underlined in red, made of that!
JJJoseph:
This alone sounds like a good reason to switch to an LED tail-light! I now realize why I've never had to change bulbs on my 15-yr old Kymco (all factory LED lights).
Navigation
[0] Message Index
Go to full version