Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Tiny

Pages: 1 ... 5 6 [7]
91
General Discussion / Re: Kymco Racing King
« on: July 18, 2016, 10:08:55 PM »
From what I've bin told the if you ever ridden or sat on a Movie150 you've pretty much have bin on the same scooter. I've coveted it since I first saw the Movie and found the Racing 180.

92
Movie 150 / Re: Exact Engine Displacement For 2014 Movie?
« on: July 14, 2016, 09:42:03 PM »
Looking at your picture your RPMs are at 10K mine only goes up to 9500 tops. I get a top speed of 107KPH(66MPH) GPS verified. What speeds you getting?

93
General Discussion / Re: Greatest car movies ever made!!
« on: July 11, 2016, 11:11:07 PM »
What about Death Race 2000?

94
Movie 150 / Re: Performance Upgrade Part 1.
« on: June 16, 2016, 01:37:31 AM »
A motor-driven cycle is a motorcycle with less than a 150 cc motor size.
NOTE: You may not operate a motor-driven cycle on a freeway or expressway if signs are posted to prohibit motor-driven cycle operation.

Straight from the DMV handbook for you

95
Movie 150 / Re: Movie 150 Review
« on: June 16, 2016, 01:27:15 AM »
Low beams are pretty good and the highs are just okay. They do the job well in the city not sure on B-roads.

96
zx50 / Re: Looking for Mirrors for zx50
« on: May 30, 2016, 08:12:03 PM »
That sucks Mate. There are plenty of aftermarket mirrors out there just make sure that the threads match. So coarse and pitch of the threads work with the ZX50 mounting locations. Hell check Ebay and you might find a pair of OEMs on there. MonsterScooterParts sell a set fo $20 http://www.monsterscooterparts.com/scooterparts/street-brands/kymco/kymco-zx50/mirrors-set-chrome.html
Good Luck

97
Movie 150 / Aftermarket Exhaust
« on: May 29, 2016, 09:37:06 PM »
Anyone know of an aftermarket exhaust that fits the Movie?

98
zx50 / Re: CDI Compatiblity
« on: May 01, 2016, 02:15:02 PM »
Managed to figure out that the CDI has no restriction and replaced it with a CDI for a Dio. It runs smooth a silk just need to tune the CVT and replace the exhaust pipe. Thanks all

99
zx50 / CDI Compatiblity
« on: April 17, 2016, 05:24:50 PM »
I would like to replace the stock CDI unit with an aftermarket one.  If I buy one that is meant for a Dio will it fit with no modifications needed?
 No I would rather not splice the Green Wires.
Thanks

100
General Discussion / Re: Stalling Issue
« on: November 09, 2014, 08:36:24 PM »
The guys at the shop check all the electrics and found there wasn't a problem there(first time it was the spark plug boot). I'll plan on calling them when they open on Tuesday to see about a carb cleaning.
 And to Tortoise I can reference a service manual just fine as I have fixed six different 50cc in the last two years with various issues from no start ,lack of/no acceleration and a few electrical problems so I am very mechanically adept. Just when my New scooter has bin in the shop with the same issue(twice) I was looking into other possibilities for concern. 

101
General Discussion / Stalling Issue
« on: November 09, 2014, 06:16:42 PM »
Hi all.
I've got a 2013 Movie 150 and shortly after I bought it this past May it started to stall when you would slow down for a stoplight or sign where you had to hold the RPMs at 3000 so it would not stall. Took it in to the shop that I bought it at for that issue and the 300KM service they said they fixed the problem and all as well till mid September then it stared to act up again.
 It spent a week at the shop as they test drove it to diagnose the problem. They found that the fuel line was clogged after the filter and replaced the lines. But now its happening again but this time when I try to get it started after a stall Appling the throttle just stalls the engine.
Any help would be gratefully welcomed.

Pages: 1 ... 5 6 [7]