Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jonboy103

Pages: [1]
1
Agility 125 / Re: Starter motor problems
« on: December 17, 2013, 10:06:29 AM »
Yes will get some today sorry, I'd say its just a mill or 2mm sticking out but I took it out and found a tiny bit of white liquid thinking a gasket had gonei drained the oil and seemed clear? Could it be just moisture got in? Iv lent a motor off a 50 keeway moped touch wood will fit.. How do I know if my tires have legal tread mate without tool does the penny method work?

2
Agility 125 / Starter motor problems
« on: December 16, 2013, 01:51:35 PM »
Hi all, I have a problem with my kymco agility I cannot for the life of me get my starter motor to sit in the lug in engine flush. I removed it as wasn't catching when pressed button and ground a bit of & eventually broke one of the brackets off thinking that was stopping it from sitting flush but no joy and don't really want use bike until its secure or wedged in postion has anyone got any ideas? Buying a new starter is out of the question at mo from what I can see there's nothing hitting the motor/engine or stopping it. Any help appreciated

3
Agility 125 / Re: Engine vin?
« on: November 28, 2013, 06:33:53 PM »
Thanks located the number was covered in crap, im lost on my starter motor issue there seems to be a bracket missing on it as doesnt bolt to anything just straight into hole in engine for it its turning over    but not catching the pinion/cog on inside of engine also the cog isnt catching on anything inside when spun i was under the impression that turned the back wheel? i dont know the exact name of it not got a manual for the exact bike just Chinese motorcycles and its not listed my first kymco and already baffled ???

4
Agility 125 / Engine vin?
« on: November 27, 2013, 01:07:36 AM »
Hi all, i have recently purchased a 2006 kymco agility 125 and to put my mind at rest i want to find the engine numbers did a HPI check on the reg plate come back clean as there was no logbook with it i was curious got a receipt etc. But i am struggling to find the engine vin number have looked pretty much all around (with engine in frame) and all i have found is KDU-E000 near main stand bolt which i found is supposedly a air cooled Honda engine? where can i find the actual vin as im struggling frame number seems fine starts with LC2 i think.. Also where would i be best to find the kick start assembly in UK reasonably priced? I was told it was just missing the shaft but all there is to it i can see is return spring and kick lever? Where does the shaft sit in drive belt casing is it a straight forward job to change. Any input appreciated  :o

Pages: [1]