1
Super 9 / Re: Does anyone still run one of these?
« on: July 10, 2022, 03:19:32 PM »
I have the same scooter. It has been the best I have had. runs great,good speed.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Super 9 / Re: malossi var.
« on: August 29, 2016, 04:59:53 PM »
Not the drive bushing. It is black about 1"in dia. and 1/4" thick
3
Super 9 / malossi var.
« on: August 29, 2016, 12:45:26 AM »
Ordered a new malossi M519988. I know about not using the spring included. Is the steel washer used?
4
zx50 / Re: Engine Oli Botton
« on: February 12, 2016, 07:19:52 PM »
your scooter is probably a 2 stroke. The oil light on the dash is for the oil reservoir.
The oil tank is next to the fuel fill under the seat. Small black cap. Fill with 2T oil. the light
will go off.
The oil tank is next to the fuel fill under the seat. Small black cap. Fill with 2T oil. the light
will go off.
5
Agility 50 / Re: Headlight bulb: LED ok?
« on: September 16, 2015, 09:55:39 PM »
read the Q&A.will not work on AC power
6
People 50 / fuel gauge wiring
« on: July 09, 2014, 08:56:40 PM »
Got a people 2t scooter, someone disconnected the wires for fuel gauge. Need to know where they are connected on the gauge.
colors black,yellow, blue/white. thank you
colors black,yellow, blue/white. thank you
7
People 50 / remove front cover
« on: April 13, 2014, 05:37:16 PM »
Is there any way to remove the front cover without removing the whole front fork??
2000 people 50 2t
2000 people 50 2t
8
zx50 / Re: Help with measuring between two points on the frame.
« on: January 27, 2014, 04:47:25 PM »
figure 1 the distance from the front to center of grab bar is 37.5 inches
9
zx50 / new cyclinder
« on: October 07, 2013, 02:38:31 PM »
Is it necessary to run a ball hone thru cyclinder when replacing?
10
zx50 / Re: Electric start won't work--Sometimes
« on: August 09, 2013, 02:21:53 AM »
Looks like the female threasd are stripped. I have repaired with JB Weld. fill the bad threads, then drill out with proper drill,rethread with 8x1.25mm tap
11
zx50 / Re: looked for sticky on service manual on zx 50 where can i find one
« on: June 10, 2013, 12:19:41 AM »
www.hondaspree.net also has a service manual
Pages: [1]