Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kymcoallan

Pages: [1] 2 3 4
1
Xciting 500 / Re: using water
« on: October 10, 2016, 08:37:13 PM »
Thank you

2
Xciting 500 / Re: using water
« on: October 10, 2016, 11:42:07 AM »
I am in Denmark and yes it is probably a good idea. I've got blue antifreeze but heg have been told that it must be Orange. It's a little confusing right now it has not lost any water

3
Xciting 500 / Re: using water
« on: October 07, 2016, 05:52:26 PM »
Can it be frost which is now at night

4
Xciting 500 / Re: using water
« on: October 07, 2016, 05:50:19 PM »
13.000 km

5
Xciting 500 / Re: using water
« on: October 07, 2016, 05:49:28 PM »
No no the failed course not. Lots of water on it this morning after a trip on the motorway was still the same amount of water. I wonder if it has been frozen so it's frozen or something. Those who I bought it from had not poured antifreeze in the water and it's stupid.

6
Xciting 500 / using water
« on: October 07, 2016, 07:52:20 AM »
My Kymco Xciting 500i year 2008-09 using water, it is strange but the water cooler disappear slowly, is this normal? what can be

7
People 250 / How do I mount the GPS on a Kymco People S 250
« on: June 16, 2014, 02:34:26 PM »
How do I mount the GPS on a Kymco People S 250

8
People 250 / Re: strap/belt and rollers
« on: April 04, 2014, 08:07:36 AM »
Thank you very much. My mechanic was in there and they had it fine. They looked fine both rem and rolls. Thank you for your good advice

9
People 250 / strap/belt and rollers
« on: March 17, 2014, 11:54:59 AM »
My good Kymco People S 251 has now passed 18,000 miles. When should I switch, strap/belt and rollers? Some say 20,000 others say 25,000 what is true. When have you changed?

10
People 250 / Re: valves
« on: September 15, 2013, 09:04:58 AM »
Thank you. Sorry that google is so bad to translate. I skurgte the entire engine had to get up / out to adjust the valves. My mechanic do it. However, this is fine

11
People 250 / Re: People 250 is slow
« on: September 14, 2013, 12:02:31 PM »
It should at least be able to run 85 mph it is my easy.

12
People 250 / valves
« on: September 14, 2013, 11:53:16 AM »
Some say that the whole engine or loosened to keep the valves on my lovely Kymco People S 251, is that true? My mechanic in Denmark therefore believe that it is very, very expensive to get asked valves? Should the engine almost loosened? is it true? Thanks in advance

13
People 250 / Wire Couplers
« on: June 27, 2013, 09:10:11 AM »
Perhaps a small problem, but it's hard to explain. When I shall have
box up on the seat in so I can get down to mortoren, seat box then there are 2
wires to be the first. One is the light down in the seat box and the other is to
a charger for mobile phone. The one with the light it's easy enough to get separated, but the
Mobile phone lets it I do not see how is assembled and can not take it apart
even if I pull at each end. How is it collected? how separated the ad? each
time I had to turn it apart and it is quite difficult especially when it is now clear
probably it is to disassemble. But how? has some experience and can help?

14
People 250 / Re: valves
« on: June 19, 2013, 08:58:57 AM »
thank you

15
People 250 / valves
« on: June 01, 2013, 10:32:28 AM »
How often should valves to / Inspect visually?
How often should the belt and rollers changed / Inspect visually?
How many kilometers?

Pages: [1] 2 3 4