Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kymcorider95

Pages: [1]
1
People GT 300i / Re: Looking for another People 300i to buy
« on: April 10, 2025, 03:38:11 PM »
FYI I have a 2013 people 300 gti for sale in the twin cities of MN. 4100 miles, new tires last summer, oil changes every summer. Have owned for 5 years.

2
People GT 300i / Re: Rear tailight issue
« on: April 10, 2025, 03:24:41 PM »
Not listed in owner's manual?
Stig
I was able to track it down via some searching on this forum. Incandescent light appears to have solved the problem. LED must have just been poor quality or not drawing enough juice.

3
People GT 300i / Re: Rear tailight issue
« on: March 19, 2025, 07:20:30 PM »
I used to be big fan of LED bulbs in my scooters but somehow they don't last long. When I found myself with no taillight in the middle of night, that was enough. I ditched all the LEDs and switched to classic bulbs for trouble free rides.
Do you know the bulb size for the People 300 gti? I want to try and purchase a standard bulb but cant find what the style of it is.

4
People GT 300i / Re: Rear tailight issue
« on: October 09, 2024, 05:40:06 PM »
@Ruffus I removed the seat last night finally but didnt have luck finding the voltage regulator. I think I might need to remove the right side body panel, but that looks a bit more intensive. I can see a small block with wires with a red and black cap that looks something like a solenoid maybe? I also see a plug with three yellow wires plugged into another three yellow wires, but this runs along the frame rail and I can't really see where it goes into the wire harness. Am I on the right path?

5
People GT 300i / Re: Rear tailight issue
« on: September 25, 2024, 03:44:43 PM »
This where the reg/rec is located at (pls see link and pic) right  behind the RH frame held with two 6mm nuts on bolts.

https://www.kymcoforum.com/index.php?topic=33615.msg235978#msg235978

If you have you reg in your hands you will see a plug with (3) three yellow cables from generator and a TWO PRONGED  connector, THERE you should measure voltage.

-red and green from reg go to your battery
-small capped plug with three pins (female) is its diagnostic connector
Thanks! Is it relatively easy to get the seat pan out? I was looking at it last night and it looks like a few things hold it on there like a 12V socket and then some nuts all the way around. I did have to replace the battery this spring despite it only being a year old. I am wondering if I have been seeing voltage issue for a bit now (this is more of a toy that primary vehicle).

6
People GT 300i / Re: Rear tailight issue
« on: September 25, 2024, 02:41:29 PM »
@kymcorider95 welcome here!

Reading your post  I would start to check my regulator/rectifier for being shot or partly demaged to produce too high a voltage.

-take a multimeter

-put leads on batterys poles or better disconnect the plug which comes with red and green from reg/rec to battery and measure there

-start the scoot
-reads more than 15.O or up to 17.0 VDC?
-if YES, your reg/rec is to be replaced

-if NO, well,  come back and we will search

LEDs are sometimes not high quality and ICs in there fail occasionally.
Where is the regulator located on these? I only see positive and negative cables in the battery tray. There is also a plug with three smaller wires that is capped and looks like a diagnostic plug. I is not running into anything that I can see.

7
People GT 300i / Re: Rear tailight issue
« on: September 20, 2024, 06:45:52 PM »
Thanks! I will make sure to check that and report back my findings. Hoping it is something easy to pin point. I'm pretty mechanically inclined and this one has thrown me for a little loop.

8
People GT 300i / Rear tailight issue
« on: September 19, 2024, 01:58:41 PM »
Hello,
I have a 2013 300GTI that seems to be having issues with the tailight. First, I bought it with an LED bulb in it and that seemed to work for awhile, then I noticed it was not working. I thought that maybe it was the wire or switch so I took apart the handlebars to check the connections. Those were all good so I started searching for a new bulb. They are nearly impossible to find it seems, and ended up getting a new one from LEDPerf. Put the bulb in and it worked great; flashes, steady on at idle, etc. Rode 4 miles to work and noticed when I went home it wasn't working again. No flash and no on at idle. Why would this keep breaking? Any easy way to trace wiring like removing the seat or body panel. Would a fuse or ground do this? Any other good sources to buy a tail light bulb besides this one foreign website? 

Pages: [1]