1
Agility 125 / clock
« on: March 07, 2026, 11:36:33 AM »
hi i have a 2015 kymco agility 125 cc 16 inch wheels the clock was fine but now will not set its flashing but will not adjust any one got any ideas what i can do? tks
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
From it's terminals, the battery measures around 13.2v with the bike turned offis it not Glass Clear Round Fuse - 10A - 2.5cm Length (25mm) i had a similar problem these worked
Using a multimeter, its black probe on the negative battery terminal, then touching each side of the red wire fuse.
Yesterday, both sides were around 13.2v.
Today, one side is 13.2v and the other is around 300v? How is that possible?
what we call a normal day we only get 361 rain days a year))
@jasbos, this carb-equipped scoots are usually bulletproof.
TPS can be resetted (pls see forum)
You say, you do have a kickstart option, right?
Does your scoot start by kicking it on?
If YES, something prevents electricity to reach your starter motor.
Culprits (possible):
- minus cable from battery to motor corroded
- plus cable to starter motor lose
- battery terminals lose
- starter relais cables lose or corroded
- stsrter relais itself
- battery charging system faulty
- brake light switch faulty
- kill switch off/on
This fault on a onecylinder/ one coil/ one regulator scoot is to be found.
Check this things or let check. If your mechanic cannot, change mechanic.
hi thanks for the information I have checked all the battery cables all seem fine I never knew there was a kill switch on the scooter where is it if I may ask and i am struggling to find a post on resetting TPI and yes it will start on kickstart but takes a lot of trys and sometimes will not
tks again for information