1
People 50 / Re: Need help!!!!
« on: January 29, 2020, 11:48:04 PM »
The solid wire that's coiled on the stator. That wire is broken in 2 different spots.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
People 50 / Re: Need help!!!!
« on: January 29, 2020, 01:54:32 PM »
Well battery I at 12.6 got new ignition coil opened up the flywheel cover and found that the stator has a couple wires that have split apart would that cause it not to have spark .?
3
People 50 / Re: Need help!!!!
« on: January 07, 2020, 03:12:54 AM »
Have multimeter now where should I start?
4
People 50 / Re: Need help!!!!
« on: December 30, 2019, 04:19:49 PM »
So I should have an eye connector for each individual wire which is a total of 4?
5
People 50 / Re: Need help!!!!
« on: December 29, 2019, 07:39:47 PM »
I meant 2 for each positive and negative should I had just put his positives in one connector and both negatives in one connector? Or is the wiring I replaced to small of a gauge to produce enough juice for spark?
6
People 50 / Re: Need help!!!!
« on: December 29, 2019, 07:36:11 PM »
The cables that connect to the battery the positive " large red & small red". Negative- large green & small green. The wires had started to to fray and break away from the connectors so I cut off both ends and re placed the connectors with 4 small ring wire connectors 2 for each wire also had to take off some length of negative wire does the wire have to be the exact same size?
7
People 50 / Re: Need help!!!!
« on: December 28, 2019, 04:08:52 AM »
Have test light yes. No multimeter.....
8
People 50 / Re: Need help!!!!
« on: December 27, 2019, 10:07:45 PM »
Well got new battery new sparkplug wire coil and still no spark wtf
9
People 50 / Re: Need help!!!!
« on: December 18, 2019, 07:26:24 AM »
Will hopefully be getting new battery soon... Will post back asap.... Thanks
10
People 50 / Re: Need help!!!!
« on: December 16, 2019, 11:18:43 PM »
But if it was running when it died wouldn't that mean the charging system isn't working properly?
Or could the battery be so dead that it just stopped charging...
?
Or could the battery be so dead that it just stopped charging...?
11
People 50 / Need help!!!!
« on: December 13, 2019, 01:05:48 PM »
First off I wanna start by saying that this forum has been a huge help so far. But I've recently encountered an issue. I was riding about 2 weeks ago and the bike was running fine just put gas and 2stroke oil in it. Was cruising along and it just died. My battery is not the best. But have charged it multiple times before and the button would start it up no problem. I am guilty of occasionally leaving the key on sometimes. But I could still kickstart it with very little problem... Now I'm getting no spark put a new plug wire/ignition coil. Is it possible that from the battery dying so often that the stator went bad? I don't have a volt or ohm meter. I would think it would almost have to be the stator or am I wrong?
Pages: [1]