Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MarcusB

Pages: [1]
1
zx50 / Re: Stops when geting warm
« on: July 29, 2018, 12:26:34 PM »
So How am i supposed to ride in the New piston do you think?

Over to the problem, What could be the issue with geting to hot. It starts really fine, a can ride 5-10 minutes and then it shuts down. Sounds like its pinching but i am not sure. It Will not start again until its cooler

2
zx50 / Re: Stops when geting warm
« on: July 28, 2018, 07:10:00 AM »
Quote from: CROSSBOLT on July 27, 2018, 08:57:38 PM
First, bad idea to let anything idle for an hour or two, especially a two-stroke. Second, ring end gap should be checked before final engine assembly. Just because the rings are for that engine and piston does not mean the end gap is right for the cylinder size.

Tell me why is it a bad Idea running a fan cooled 2 stroke on idle?

3
zx50 / Re: Stops when geting warm
« on: July 28, 2018, 06:40:29 AM »
Well that Did not help me at all... someone with something more constructive

4
zx50 / Stops when geting warm
« on: July 27, 2018, 08:51:17 PM »
Ok, New thread...

I had an issue with my scooter not starting. Found an Fawlty piston and rings. Every rhing else seende fine. Changed piston and rings and gaskets. Started up right away.

Had it running on idle for an hour or two, then started to run it but slow. Now its dying when it gets hot, it seems like its pinching. A soon as it cools down it starts right up like before.

It is original cylinder, and i got an original piston with rings. What am i doing wrong?

5
zx50 / Re: Will not start
« on: July 23, 2018, 10:24:15 AM »
The piston had a little hole, the rings where broken. But the cylinder was ok, so i changed Pistons and rings, and all the gaskets. Started right away.

Thanx!

6
zx50 / Re: Will not start
« on: July 13, 2018, 04:35:49 AM »
Thanx, i ordered new gaskets and rings just inncase Will brand it down soon. Will let you know asap

7
zx50 / Re: Will not start
« on: July 12, 2018, 05:36:07 PM »
I dont know, i got it for free...

Will not start with Ethergas either.

I have followed the service trouble manual, and got stuck on the compression.

How can i test if the spark is good enough?

8
zx50 / Will not start
« on: July 12, 2018, 08:17:26 AM »
My ZX Will not start. The sparkplug is moist, and has got spark.

I can only measure halfe the recomennded preassure in cylinder (4kg cm2)

What would be the mest step recomended? Can the reed’s be faulty?

Pages: [1]