Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Andy_myguy

Pages: [1]

Agility 50 / New Jets

« on: March 21, 2022, 11:41:28 PM »

Does anyone have a link to where I can buy new jets for the carb? I ordered “carburetor main jet 101 for Keihin M5 - 088” off of scooterpartshop.com but they were too big. Does anyone know the correct size? Is it M4? Also stock is 82 what should I start off replacing it with to get a bump in speed?

General Discussion / My Kymco Agility 50 won’t start after oil change

« on: March 21, 2022, 04:59:28 PM »

I just changed the oil in my Agility 50 (used 10w-40 synthetic). Also changed the gear oil (used 80w- 90) and cleaned the air filter.

First, I want to say I don’t really know what I’m doing. I had watched videos teaching me how to do each of those tasks but I may have still done them wrong.

After draining out old oil, I put 750ml of 10w-40 in which was the recommended amount. However it was too full and the Oil nearly spilled out. So I drained some of the oil until it had the right reading on the dipstick.

I also cleaned air filter using brake parts cleaner (I know that’s not what it’s meant for but that was the only clear I had lol) I got impatient and put it on while it wasn’t 100% dry.

Started her up and 30 seconds later she shut off. Haven’t been able to get her started since. She just turns over even when I use starter fluid.

The battery is new, I tested spark plug and it works, I have since cleaned the carburetor and tried changing the oil again. I’m running out of ideas of what the issue could be. Any help?

Agility 50 / Scooter won’t start after an oil change

« on: March 19, 2022, 08:17:07 PM »

I just changed the oil in my Agility 50 (used 10w-40 synthetic). Also changed the gear oil (used 80w- 90) and cleaned the air filter.

First, I want to say I don’t really know what I’m doing. I had watched videos teaching me how to do each of those tasks but I may have still done them wrong.

After draining out old oil, I put 750ml of 10w-40 in which was the recommended amount. However it was too full and the Oil nearly spilled out. So I drained some of the oil until it had the right reading on the dipstick.

I also cleaned oil filter using brake parts cleaner (I know that’s not what it’s meant for but that was the only clear I had lol) I got impatient and put it on while it wasn’t 100% dry.

Started her up and 30 seconds later she shut off. Haven’t been able to get her started since. She just turns over.

The battery is new, spark plug works, I have since cleaned the carburetor and tried changing the oil again. I’m running out of ideas of what it could be. Any help?