KymcoForum.com
General => Technical | How To => Topic started by: Rafterman on December 30, 2016, 01:11:57 AM
-
Good day. I need some help i was planning on a little diy on installing additional lights for my S8 125 the problem is i dont know where to connect the wires.can someone help me with a wiring diagram.thanks a lot.
-
if you are hooking up spot-lights to add to the headlights , I would hook up to the headlight wires,. low watt LED lights , adding to the rear, hook up to the tail light wires, not the brake wire, and keep track of the total wattage, keep it low,.
-
I just added a strip of LED's to the rear of my DT300i. I went straight to the tail light/stop light socket
and removed it, so I had room the connect the LRD wires, using the single wire clamp on connector. The solid brown wire is the tail light wire and the green w/stripe is stop light and the solid green is ground. Haven't added to front lighting. As de dee said, keep your drain on the system as low as possible. LED strips require very low wattage. Hope this helps.
Mac, aka "ole two wheels"