KymcoForum.com
Scooters - 125 to 300 => People 250 => Topic started by: kymcoallan on June 27, 2013, 09:10:11 AM
-
Perhaps a small problem, but it's hard to explain. When I shall have
box up on the seat in so I can get down to mortoren, seat box then there are 2
wires to be the first. One is the light down in the seat box and the other is to
a charger for mobile phone. The one with the light it's easy enough to get separated, but the
Mobile phone lets it I do not see how is assembled and can not take it apart
even if I pull at each end. How is it collected? how separated the ad? each
time I had to turn it apart and it is quite difficult especially when it is now clear
probably it is to disassemble. But how? has some experience and can help?
-
Mine has a simple clip that you have to pry up while seperating the wires. It might be tied to the frame farther down the wire
-
That plug is a pita!! I always have trouble with it. It is very simple once you figure out where to lift up tab. I always have to get one of the guys in my shop to do it.
:)>>
-
I just did this the other night.
Disconnect the battery.
Then disconnect the lamp by pulling the lamp housing out 1st, the uncoupling the disconnect. Then I pulled the plastic tub out from the under seat but still had the charger plug connectedso the tub was only partially up. I got access to the disconnect for the charger plug at the rear of the space. Easy Peasy from there on.
-
What is under the seat box you need to access?
-
when you do a service check up,. ckecking Battery, fuses, if one has blown, and easy to clean a little, and the spark plug,.