KymcoForum.com
Scooters - 50cc => Agility 50 => Topic started by: scooterman11 on May 17, 2013, 08:03:06 PM
-
I know for a fact my auto choke isn't working on my 08 agility 50, I have replaced it many times and they still don't work, how do I test it and I'm sure I have a electrical problem!
-
How to test an Auto Bystarter (choke) Electronic Choke Honda Yamaha Chinese mopeds and ATV (http://www.youtube.com/watch?v=2PXd0pootTQ#)
-
Here's the schematic, maybe your resistor is bad?
-
Is that a part of my wiring harness or is it included with the new auto enricher, because the auto enricher plugs in to my wiring system?
-
To buy pass all that. You can put in a gravity flow gas tank. And then you can also take off the emission controil. you can use the same tank but you need to take off the peadcock and replace with a new valve. scoot runns great like that. stops all the guessing with if gas is geting to the carb. I have a gy6 scoot I have been running like that for years eats up more gas but scoot runns great.
-
Well from that drawing it looks like the G/B wire goes to it. Maybe meter that wire to gnd and see if you have 5 ohms?
-
i though i remember seeing a manual choke conversion kit, cant remember where but i am thinking about one myself because my choke doesnt like to shut off all the way while riding i need to shut down the engine and restart
-
There was a discussion on that a little while ago. See here;
http://www.kymcoforum.com/index.php?topic=8492.msg93647#msg93647 (http://www.kymcoforum.com/index.php?topic=8492.msg93647#msg93647)
-
Nice Ill have to check in to that............
-
Hey guys where is this resistor, Is it farther down by the battery