KymcoForum.com
Scooters - 125 to 300 => People 250 => Topic started by: Ray on October 26, 2012, 11:54:13 AM
-
I recently got at 2006 People 250. I have a top case with brake and running light LEDs. Short of removing a lot of plastic, is there a way to access the needed wiring harness (maybe by removing the storage bin)? I really appreciate any ideas. Thanks.
-
For my Grand Dink 250 I've had to remove the trunk and seat assembly to get to the rear light's wiring harness so i could connect my top case lights that I've had to make by myself. The top case didn't had any lights, only a red transparent plastic, so i've bought around 40 cm's of red light, self adhesive LED strip and placed them under the red plastic and connected them in parallel and the LED strip assembly connected them to the rear light wiring harness. I've also added a connector on the wiring to remove the top case more easily.
(https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-prn1/551428_531965030169411_1633782497_n.jpg)
(https://fbcdn-sphotos-a-a.akamaihd.net/hphotos-ak-ash3/535783_531965036836077_576053456_n.jpg)
(https://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-ash3/563254_531965050169409_1676410982_n.jpg)
(https://fbcdn-sphotos-e-a.akamaihd.net/hphotos-ak-ash4/382312_531965120169402_337751172_n.jpg)
There are three strips: the center strip is the rear light and the upper and lower strips are for the breaking light.
(https://fbcdn-sphotos-b-a.akamaihd.net/hphotos-ak-ash3/579755_531964956836085_1469234925_n.jpg)
-
Just pull the seat/storage bin out and you can access the wires you need as they run back past the seat latch area. According to the schematics, you'll need to attach to these wires:
Green (solid): Ground
Green with Yellow stripe: Brake Light
Brown (solid): Tail Light
If you need more in the way of manuals or schematics, look here:
http://scootdawg.proboards.com/index.cgi?action=gotopost&board=200cc&thread=6804&post=65236 (http://scootdawg.proboards.com/index.cgi?action=gotopost&board=200cc&thread=6804&post=65236)
DSC