KymcoForum.com

Scooters - 50cc => Super 8 => Topic started by: PandersonPrime on April 15, 2012, 04:43:07 PM

Title: The bolt holding the rear turn signal assembly
Post by: PandersonPrime on April 15, 2012, 04:43:07 PM

After i just bought the scooter, i noticed the entire left rear side of the turn signal was loose. After just touching it, it fell off. I then noticed the bolt had been stripped and needed to be replaced. I'm having a difficult time tracking down the size of the bolt to replace it. What is the size of the bolt?

Title: Re: The bolt holding the rear turn signal assembly
Post by: ill_eagle94 on April 15, 2012, 09:17:03 PM

I'd just bring the bolt to your local hardware store and see what it is. It's how I made a new pivot bolt for my left brake lever.

Title: Re: The bolt holding the rear turn signal assembly
Post by: PandersonPrime on April 15, 2012, 10:08:10 PM

yeah i tried that..Lowes.. of all places...no luck, they couldn't match the bolt...
is there a website or a parts diagram to the make and model of scoot i can refer to and get the exact measurement, maybe?

Title: Re: The bolt holding the rear turn signal assembly
Post by: juice on April 15, 2012, 11:12:28 PM

Google the word "fasteners" followed by your zip code , that should bring up any specialty shops that can find your thread size . Good luck .

Title: Re: The bolt holding the rear turn signal assembly
Post by: zombie on April 15, 2012, 11:25:30 PM

Can you post a pict? My local hardware carries all the bolts I need for my scoots (Ace Hardware). Lowes has to have them too. I think you just had poor help. Most all the bolts on your scoot are 6mm x 1.0 or 1.5mm. The 1.mm is fine thread, and the 1.5 is coarse.