KymcoForum.com
Scooters - 50cc => Super 9 => Topic started by: wordslinger on April 15, 2012, 12:36:41 AM
-
..nina, my 2005 50cc...2000 miles...
..Malossi air filter, 38 pilot jet, out 1.5 turns on th screw..
..117 main in th oem carb...
..oem exhaust..
..naraku vari onna 1.475 drive boss, slinging 6gram sliders..
..Gates premium, not kev 743-20-30 belt,
..unrestricted 2001 ppl driven pulley and torque driver
..malossi blue 1500 contra and a malossi delta clutch set oem, with oem kymco bell..
-
...nice and brown, but the residue around the interior concerns me...
-
...still a bit too much oil in the mix??
-
If you mean the redish color... That's Ethanol my friend. It burns hotter giving that red ash from the oil. Non eth will just be brown/black
-
I didn't click the picts. Now I see it.
If you cut down by 10% on the oil you may get a better result. That goo will clog up the rings.
-
Red color looks like from the MMT additive in the gasoline that they used in place of Tetraethyl Lead. But I know it's already banned in the US and Canada but not in Australia. I don't know if some U.S. refineries still use this.
-
MMT is a much better additive (oxygenater) but is apparently too expensive for us peasants in the US. Eth make red ash as well. It is not the Eth. but actually the superheated soot from the 2t oil. The Eth. releases Oxygen that increases combustion temp, and super heats the soot. Full Synth 2t oils do not have this issue, as they leave no soot to burn.
-
Full Synth 2t oils do not have this issue, as they leave no soot to burn
..i'm running Interceptor.....
-
Switch... It's not working
http://www.spectro-oils.com/?p=235 (http://www.spectro-oils.com/?p=235)
I've used it in every bike I've owned
-
For plug chops, I learned the rope by reading and following Roost's article:
http://www.roost.si/tech/How%20to%20properly%20read%20the%20carburettor%20jetting.pdf (http://www.roost.si/tech/How%20to%20properly%20read%20the%20carburettor%20jetting.pdf)
Didn't know if you've already seen it or not, so figured I'd post it up there.
~Josh
-
Going by Roost (good thing) slinger is showing proper heat range/too much oil? or oil not burning? Too rich?
I think it's the oil itself. Too much/not "clean burning". The A.F. ratio looks spot on. Just my opinion...
Try a bottle of Spectro. You may be surprised.
-
50 mile plug, I assume at WOT? Looks good to me. Nice and safe. Does everything seem to drive fine?
~Josh
-
Did you zoom the picts. J.? There is a lot of "varnish" looking stuff near the mix ring. That is the stuff I'm referring too. The af mix, and the temp look great.
-
should have finished... I've never seen that in my plugs... That's why I'm suggesting/asking. Wut is dat?
-
..as i've indexed the oil pump back to the center of the V, the "varnish" is gone away...see my "60 mile plug" post..
For plug chops, I learned the rope by reading and following Roost's article
..i just read that, and it's very informative!!..thanx, josh!!
..this plug was what i ran for a day and a half, on my ride to work and back, which is 80% wot...
..she runs like a raped ape!...only issue i have, is on colder mornings, it wants to bog just off idle, like when i'm taking off at a traffic light...actually shut down this morning..
-
..as i've indexed the oil pump back to the center of the V, the "varnish" is gone away...see my "60 mile plug" post..
One down, and one to go.
Have you tried a larger Pilot jet? That may help with the heat too. (bog off idle)
-
Summer time... Less dense air.
-
...its been unseasonably cool here, of late...40 this morning, low to mid 30s tonite, with a 10-20mph wind...