KymcoForum.com
General => Technical | How To => Topic started by: fshfindr on March 14, 2012, 03:14:10 PM
-
Hi guys, I'm looking for the best way to mount my Garmin Nuvi 250W on my Yager. I did a search which led me in diff. directions. I saw the mount that attached at the base of the mirror, and right know that is my current choice. I have the suction base with a ball on but it won't stick on the bike. If I knew what was under the plastic covering the handlebar, I could drill a hole or two and mount it there. I know some of you have installed the nuvi on your scoot. Now I'd like to get into your brains for some advise on what works best for you.
Richard L.
-
I know most people prefer to use RAM mounts, however I was on the cheap and also preferred a location off of the handlebars on my XC500. Yes, I did screw the base of the GPS onto the plastic fairing. I also cross drilled a hole through the pivot point of the GPS mount to a position where I would not change it. This allowed me to install a nut and bolt to keep the GPS from moving about from vibrations. All hardware used is stainless steel. (I had a spare mount to use for drilling that was not being used otherwise) I also hardwired the GPS to come on with the ignition and shut off when the bike is turned off. You will have to order a hardwire kit to go with your GPS.
(http://i191.photobucket.com/albums/z229/Chandlerazman/500RifloorboardsE.jpg)
-
Yeah, yours looks great, maybe a little low where you may have to change your focus, but I’m sure it works well. Neat scoot. I ordered the stem that attaches to the mirror base. Without removing the plastic, I was afraid to drill anywhere. Thinking about it know, I could have removed the plastic on the handlebar and maybe drilled into it. Four screws hold it on. Hopefully, the stem will be just as good as yours. I am concerned about vibration. I just joined a meetup group so I will need the GPS to ride with them.
Thanks for the reply,
Richard L.
-
I just got a mirror mount on Amazon for $18.00 and it works great, only problem , hard to see screen in sunlight
-
Yes, I now have the Ram mount and I really like it. But I have the same problem with sunlight. I have seen some with cardboard shades built around it. That really looks like Hell. I hope someone here has a better idea. Maybe a coating or something like that that works. I did get one good idea from a club member, I haven't tried it yet but matching your cell phone blue tooth earpiece to the GPS should allow you to hear the GPS.
Richard L.
-
I have a ram mount on the right brake fluid container on my DT300i. I can move it to keep a view of it in the sun and can hear it when running.
(http://img.tapatalk.com/4ac69755-0cdc-4bf4.jpg)
Sorry I don't have a closer picture.