KymcoForum.com
General => Technical | How To => Topic started by: super9-87 on March 06, 2012, 04:49:59 PM
-
I have a 2005 super9 lc I picked up 4 700 bucks and it needed tuned so got it done a repable shop and now it stalls at idle he tells me it might be my crank bearing I dont c how that could happen any idea on how or what it could b
-
I'm thinking carb issue but i'm no master.....
You can check the crank bearings yourself.....
Remove the cvt cover, var, belt. Try and wiggle the crank in/out... up/down. If you have more than 1mm play, then maybe he is correct.... The other side, remove the water pump and wiggle the crank...
My 1st thought is still carb.. mix screw is off not letting it idle...
Maybe some of the other guys will chime in on this and see if i'm close.. ;D ::)
-
my thoughts are...if the crank bearings were that bad it wouldn't start at all, so if it idles without making too much noise i would guess fuel/air. Blocked jet or hole in the diaphragm?
-
I'm guessing bad bearing/s would cause extra resistance that would slow the engine at idle to the point it stalls ???
Seems like that would rarely happen. I don't know ???
-
I'm guessing bad bearing/s would cause extra resistance that would slow the engine at idle to the point it stalls ???
Seems like that would rarely happen. I don't know ???
When my crank BROKE inhalf... The dam motor was still running. I CUT IT OFF
Another reason to think of carb issue.... IDK
-
Well it only has 5800 miles and only dose it when its hot it will run around 50+ all day its when I come off gas
-
See.. I'm still thinking carb issue... It's like a jet is wrong on DE acceleration.
With an electrical issue, it would do it when hot but no just when de accelerating.
Maybe Z or word will check in soon and chime in as well
-
Idk im New to scooters so I will just mess with it and try to figure it out any other suggestion well b taken thanks 4 the help
-
Take it to a different shop.