KymcoForum.com

General => General Discussion => Topic started by: blue on June 06, 2011, 10:30:23 AM

Title: carb
Post by: blue on June 06, 2011, 10:30:23 AM

is it ok to use seal a gasket on a carb.

Title: Re: carb
Post by: sidthesloth on June 06, 2011, 11:46:07 AM

I am not familiar with that product, but if it states as being suitable for use with fuel, it would be ok.

Title: Re: carb
Post by: Portland Steve on June 08, 2011, 08:02:36 PM

If it is the liquid stuff, I hate it.
Try to get the actual gasket material if you can.

Title: Re: carb
Post by: blue on June 08, 2011, 09:06:02 PM

to late im already trying it.so far so good.nock on wood hope it hold up.I only needed a little in one spot on the carb.most of it staed on the outside.

Title: Re: carb
Post by: streido on June 08, 2011, 09:27:30 PM

Are all agility 50 stock carbs the same? Does anyone know if you can buy a new rubber gasket for the bottom end? When I changed my jet I saw mine was a bit distorted and I had to use gasket sealer to secure it in place when I put it back on, was going to put a new one if if you can buy them?

If you can buy them what carb is it on a stock agility 50 from jan 2008?

Title: Re: carb
Post by: blue on June 08, 2011, 10:53:10 PM

Im useing a seal from off a gy6 carb some run the same but look close at theam some are a slight diff.

Title: Re: carb
Post by: macocoy on June 08, 2011, 11:37:44 PM

Useing?theam?

Title: Re: carb
Post by: blue on June 09, 2011, 12:53:27 PM

Quote from: macocoy on June 08, 2011, 11:37:44 PM

Useing?theam?   

lol ya I know but it works.its been in the scoot for a week now and no leaks seal pretty good.
had to put seal a gasket with in in one spot that was tore because it cam of a old scoot.