KymcoForum.com

General => Technical | How To => Topic started by: jaguar on May 26, 2011, 03:40:47 PM

Title: How to get to the sparkplug on a People S 200
Post by: jaguar on May 26, 2011, 03:40:47 PM

Greetings,

Has anyone done the basic ripdown to get to the sparkplug?  I have been following an online tutorial and am at the point where the shell should pull off the body and it still seems fairly firmly attached to the body.  Anyone with experience here?

Thanks,
John

Title: Re: How to get to the sparkplug on a People S 200
Post by: old geezer on May 26, 2011, 11:12:12 PM

http://scooterfan.wordpress.com/2008/08/27/s200-maintenance-spark-plug/ (http://scooterfan.wordpress.com/2008/08/27/s200-maintenance-spark-plug/)

Title: Re: How to get to the sparkplug on a People S 200
Post by: old geezer on May 27, 2011, 08:49:02 PM

When you get the sparkplug out the gap is .6 to .7 mm or .023 to .027 thousands.

Title: Re: How to get to the sparkplug on a People S 200
Post by: blue on May 28, 2011, 12:34:47 AM

Darn plastic.

Title: Re: How to get to the sparkplug on a People S 200
Post by: Drbeastmaster on August 23, 2011, 06:12:00 AM

thx great post/forum

Title: Re: How to get to the sparkplug on a People S 200
Post by: gammtka on August 31, 2011, 09:24:52 AM

Not sure about the People model, but here's how I got the front cover (the one by your heels when your sitting)off my Grand Vista.  Take out two screws on the floor board and the big headed green screw in the front of the met in box.  Then you must kinda squeeze both sides of the panel to release them from the tabs on both sides of the panel.  Good luck!

Title: Re: How to get to the sparkplug on a People S 200
Post by: raybus on April 16, 2012, 04:29:31 PM

Just remove the seat tub(5 nuts).Some dexterity after that but not too ha
rd.