KymcoForum.com
General => General Discussion => Topic started by: kymco God on April 09, 2011, 09:32:47 AM
-
the subject says it all, got any idea whats wrong with it?
cheers guys
-
Remove vario cover, check the belt and then the clutch.
-
cheers
-
i have tryed that but still the same, every thing in that area is fine and works correctly, got anyother suggestions?
cheers
-
With the scooter on main stand, removed vario cover and engine running you should see the rear wheel spinning - or why not.
May be it seems to work fine trying on center stand, but there is not enough force tranferred to the rear wheel for real driving/acceleration. Clutch slipping or engine weak.
-
KG,
When you removed the CVT cover and started the bike... and rev'd the engine... What did you see?
-
LOL! If everything was fine it would work. ;D
Here's what we need to know:
On the centerstand, with the Variator cover off, and the engine revving:
- Does the front pulley move?
- Is the belt moving?
- Is the rear pulley moving?
- Is the rear tire moving?
From there, we can point you in the right direction!
-
cheers for all the replys, and yes all of that is working...it is hard to explain over this forum without you seeing it, but when i pull the throttle all the way back, it revs but only moves a little, then it will just pick up again, sounds like something is slipping?
cheers guys
-
I'd take the clutch off and look for worn out pads or binding pivot points on the pads. The other thing to do is a compression check on the engine. As ts1 said, it would seem to be either in the clutch or else a weak engine.
-
Best Case: Clutch problems - Take it off and make sure everything moves as it should. This would be my current bet.
Worst Case: Your differential is destroyed - With the variator cover off, and the motor off, rotate the back tire by hand. What does the rear pulley do?
-
In one of K God's previous posts he was having trouble with the rear brake . Is it possible that he may have over adjusted the rear brakes resulting in the rear wheel not turning when the motor is reved ? Good luck .
-
there is no play in the crank, it is all fine down in that dipartment, and i have new clutch pads on...lol got no idea what to do
thanks for your help :)
-
Best Case: Clutch problems - Take it off and make sure everything moves as it should. This would be my current bet.
Worst Case: Your differential is destroyed - With the variator cover off, and the motor off, rotate the back tire by hand. What does the rear pulley do?
when it is on the3 center stand and i rev it, the rear wheel moves completely fine
-
possibly the rollers stuck inside the variator and not pushing the variator sides together? I don't think you mentioned whether or not the variator was moving in and out with the belt moving to the outside diameter of the variator. :-\