KymcoForum.com

General => Technical | How To => Topic started by: Ruffus on April 16, 2026, 10:43:38 AM

Title: XCiting 300i, clutch riddle?
Post by: Ruffus on April 16, 2026, 10:43:38 AM

Got hold of a clutch for an XC 300i with some welding spots on the rearside (gearwards).

This spotweld points held something. Why and for what purpose, I cannot say.

Bench tested the whole piece, all fine, no rough spots at bearings.

Fieldtest: put it in my XC 300 and it runs smooth and without any flaw.

Can only think of: guy wanted to change bearings (rollerbearing) and oilseals, couldn't get a grip on it, welded some pipe or similar on it, repaired and cut "holders" off again.

And NO, the whole calotte wasn't cut off and rewelded.

But as said, runs nicely and noiseless (as far our CVTs are noiseless).

Title: Re: XCiting 300i, clutch riddle?
Post by: Iahawk on April 16, 2026, 12:44:59 PM

Ruffus, your guess seems plausible. Did you pick this part up for a spare to use later, if needed?

Title: Re: XCiting 300i, clutch riddle?
Post by: Ruffus on April 16, 2026, 07:38:58 PM

Yes, as a spare just to have it in case of need. Was a few €€
.