KymcoForum.com
General => Technical | How To => Topic started by: stingray on February 03, 2025, 04:32:15 PM
-
Hi guys, I'm looking to put an indicator buzzer on the Kymco, looks like I need to take the nose cone off to get at the indicator wires, I really dont want to do that so I looked at wiring to the rear indicators, I can see the wires (orange nearside & blue offside but I just cant see how to get at them to put a 'scotch' connector in. Any ideas?, regards.
-
Can you go up in this way? (my LIKE200i)
These two push-rivets pop out and the black plastic panel comes out - revealing the wires.
(https://i.postimg.cc/90JHPVsz/Capture2.jpg)
Stig
-
A way might be to change your rear bulbs against acustic ones...
-
Hi guys, I'm looking to put an indicator buzzer on the Kymco, looks like I need to take the nose cone off to get at the indicator wires, I really dont want to do that so I looked at wiring to the rear indicators, I can see the wires (orange nearside & blue offside but I just cant see how to get at them to put a 'scotch' connector in. Any ideas?, regards.
aack!! don't use those things, good way to introduce corrosion and get the green cancer of the wire harness, personally, I don't even like "posi-taps" I have constructed pigtails that can be added between existing connectors
-
Can you go up in this way? (my LIKE200i)
These two push-rivets pop out and the black plastic panel comes out - revealing the wires.
(https://i.postimg.cc/90JHPVsz/Capture2.jpg)
Stig
Wish I had known this method, it would have been a lot easier, I did manage to fit them but an extremely fiddly job, I could get the 'scotch' clip on but very difficult to close it with the pliers, took me about an hour & numerous attempts.
Only fitted because I'm forever leaving indicators on.
Ride safe.