KymcoForum.com
Scooters - 50cc => Agility 50 => Topic started by: cooper on October 25, 2010, 05:04:43 PM
-
just started on it a week ago will have pic up later but lots of new mods had to add. let me know if any one has done it yet
-
Welcome to the forum Cooper. ;D
-
thanks
-
welcome...
I've only done the 72cc upgrade. I've never seen a 100cc.
-
why would you do a 100cc up grade when you can just buy a 125 buy the time you up grade you all ready spend that much.
-
why would you do a 100cc up grade when you can just buy a 125 buy the time you up grade you all ready spend that much.
..welll, not if you only gave a few hundred for the USED scoot to begin with........
;)
-
let me know if any one has done it yet
..no one has, and i hope you did purchase "Name Brand" upgrade parts......
-
It only cost me about 300 so it was not to bad and the only hard thing was taking the case of part to put in the bearings that was real pain in the butt but I get a bigger cam and a slip on exhaust not to bad just trying to find right jets
-
...i'd start with a 110 main...
..do long plug chops at WOT to determine where to go from there......
-
I got some then they sent the wrong ones the thread did not match up with the factory ones any good sight for jets
-
..a lot of us here drill or own jets with pin-drills or torch tip cleaning sets...
..i own four extra jets...two for the a50 and two for the ppls..
..i solder and drill them to whatever diameter i want...
-
Well I only have one so I mess up I need to buy one
-
...that's the beauty of it...you only need one...
..if you drill too big, just solder and re-drill smaller...
-
Well now I am having some trouble I put a new jet, coil, cam and spark plug in and will not start it got compression, gas and fire what do I need to look for pleas help
-
...check and SET your valve clearance....
-
Found it. It was the brand new gasket are a burnout wow
-
So whats happening?
the suspense is killing me. I hope it'll last.
-
Still no gasket