KymcoForum.com
General => General Discussion => Topic started by: roaldn on July 28, 2008, 12:34:08 PM
-
Hi Y'all
I own a 2007 People S200 that I bought in Florida last winter. It now has 6500 km (4000+ miles) and running great. Except for a problem with vibration. It started shortly after I began riding it, then it seemed to go away again but now it is getting really bad. It happens when you first rev up to begin moving and as you pick up speed it goes away.
I read elsewhere about the gear oil fill quantity. When I changed the gear oil the first time I too filled to the underside of the fill hole. This resulted in oil leaking out from the drain hole in the bottom of the air filter box. The gear box has a vent tube going into the air box. This went on for awhile and made a mess of the rear end of the scooter. I then drained the gearbox again and refilled with 180 ml and have not had any leakage since.
If anyone know anything about the vibation problem, I would like to hear about it.
-
Sounds like the clutch maybe glazed..Simple fix....Hold your rear brake tightly locked and rev your engine for a few seconds..This will remove the glaze off the clutch plates..
Your noise/vibration should be gone
OlBull
-
Hi again.
This note is for OlBull.
You were right on the mark. Problem solved using your suggestion.
Thanks a lot.
roaldn
-
I read that the owners manual is in error.
It says to fill until oil comes out the bottom of the fill hole.
That's not right - that would be too much oil.
I think Kymco released a service note saying to only ad the specified amount and no more.
Kevin
-
Check your roller weights. They may be off balance, or out of shape. I had a similar problem with my Yager GT 200i and it went away when my mechanic say that the weights weren't symmetrical.
Hope you solve the problem.
-Wolf
-
The op made that post in July of 2008. I'll bet he found the problem way before now.