KymcoForum.com

Scooters - 125 to 300 => LIKE 200i => Topic started by: Stig / Major Tom on April 21, 2017, 05:43:49 PM

Title: Treating corrosion on my LIKE
Post by: Stig / Major Tom on April 21, 2017, 05:43:49 PM

ACF-50 corrosion treatment....Yesterday...
Used soft brushes and 'green' cleaner to clean as much as I could. Rinsed with hot water spray.
Let dry....then used the can's spray wand , but mostly the soft old paintbrush to apply the ACF-50 product.

Applied to exhaust, engine, CVT cover, every external panel screw, chrome crash bars, shocks, etc. Careful to keep it off of the tires and brake discs. After 1/2 hour wiped it down.

(https://s9.postimg.org/qm3gkkqwf/clean4.jpg)

(https://s22.postimg.org/loos3vo1t/clean5.jpg)

(https://s28.postimg.org/8g7prngot/clean.jpg)

(https://s3.postimg.org/ouqz9zojn/clean7.jpg)

(https://s23.postimg.org/i04tuj217/clean1.jpg)


It did smoke pretty good on my first ride this morning - but was expecting this - and 15 mins later did not notice any smoke at a stop light. The smell lingers on at the end of one ride, but no smoke.
Tomorrow, I will remove the seat bucket and treat under there.

Found the most corrosion to be rust on the center stand cross-bars.
Stig

Title: Re: Treating corrosion on my LIKE
Post by: Redk on May 10, 2017, 05:08:14 PM

Gosh, Stig !

That is almost showroom condition !
How many miles on it now ???

...Might take an extra application here...