KymcoForum.com

Scooters - 125 to 300 => Downtown 300 => Topic started by: feebleknievel on December 08, 2016, 09:52:12 PM

Title: CHANGING THE DRIVE CLUTCH
Post by: feebleknievel on December 08, 2016, 09:52:12 PM

NEED A clutch spring compressor tool ANY IDEA WHERE I CAN GET 1 OR OTHER DIEAS TO TAKE THIS CLUTCH DRIVE APART TO CHANGE THE RUBBER SEALS  THANK YOU

Title: Re: CHANGING THE DRIVE CLUTCH
Post by: Mr. Paul on December 08, 2016, 11:02:40 PM

You don't really need a spring compressor tool to take the clutch apart. I put the clutch on the ground and compress it on one side with my knee or foot while compressing the opposite side with my hand. I then just unscrew the nut and release the pressure. It does have a little force, but not a tremendous amount. As far as removal of the large clutch nut, here is a link to the method that I have used many times. Works like a charm.

https://www.youtube.com/watch?v=aEDdglsl9PM (https://www.youtube.com/watch?v=aEDdglsl9PM)

Title: Re: CHANGING THE DRIVE CLUTCH
Post by: feebleknievel on December 08, 2016, 11:53:18 PM

Thank you and that worked out just fine it's always appreciated.:)

Title: Re: CHANGING THE DRIVE CLUTCH
Post by: Mr. Paul on December 09, 2016, 10:48:28 AM

Quote from: feebleknievel on December 08, 2016, 11:53:18 PM

Thank you and that worked out just fine it's always appreciated.:)

 :) :) :)