KymcoForum.com

General => Technical | How To => Topic started by: floyd2133 on October 03, 2016, 12:00:59 AM

Title: Starter or bendix problems
Post by: floyd2133 on October 03, 2016, 12:00:59 AM

Starter is spinning but bendix is not enhancing fly wheel

2 vids 1 pix

Video

youtu.be/bbLjrNfRiZE

youtu.be/WSp_d7jGrfg


Pic


a68.tinypic.com/nqsbqt.jpg


a68.tinypic.com/2ebamib.jpg

Any suggestions it worked this morning but now just spins

Here is better video I'm trying to figure out do I need a bendix or starter. Also the bushing in this video on the belt side were the bendix tip goes is warped I can see it in video. 'My bendix doesn't sit up right and I have a hard time getting cvt on

youtu.be/yyJNMIDIrHc

Read more: http://49ccscoot.proboards.com/thread/17172/starter-bendix-bad?page=1#ixzz4LyW4iXsr



https://vimeo.com/185255849 (https://vimeo.com/185255849)(http://uploads.tapatalk-cdn.com/20161002/32426bdc5a27572797d286ba692dadc1.jpg)https://vimeo.com/185255975 (https://vimeo.com/185255975)https://vimeo.com/185256033 (https://vimeo.com/185256033)


Sent from my iPhone using Tapatalk

Title: Re: Starter or bendix problems
Post by: JJJoseph on October 04, 2016, 09:23:00 AM

In the large photo, the starter gear should be engaged with the fine-tooth gear on the bendix assembly.  Your photo doesn't show that.  There's a gap between the gears when they should be engaged.  I can't give any more suggestions at this distance.  For instance, are the starter attach bolts fully tightened? Is it the correct starter? etc :-(