KymcoForum.com
General => General Discussion => Topic started by: PaulF on August 28, 2016, 01:15:51 AM
-
What do you guys use. I have a Jamec Pem gauge that is ok on the front tyre but can't use it on the back so I purchased a small SLIME digital gauge with the angle fitting and that worked great for about two weeks and then it played up. My pump struggles to fit both tyres.
Here is a link to the SLIME gauge. http://www.slime.com/us/products/auto/gauges/digital/5-150-digital-gauge.php (http://www.slime.com/us/products/auto/gauges/digital/5-150-digital-gauge.php)
When it played up I thought maybe the battery might be low so took of the back to replace it and found that it was set in place and the lcd screen fell off.
-
I use a Joe Blow large volume mountain bicycle pump. It has a built in air guage and since I mountain bike, I already had it.
-
Looks like a good pump but since the LIKE only has 12" rims it is hard to get a valve connector in there and then flip up the locking lever.
-
I use this to check the pressure. (http://uploads.tapatalk-cdn.com/20160828/9830181aeb260cd8f4ff760fcfb309a1.jpg) and then I use a set up like this to fill, if neededd(http://uploads.tapatalk-cdn.com/20160828/ed1dd8c63c82886596352ab7f7b64c9e.jpg)
Sent from my iPad using Tapatalk
-
Cheers mate, thanks for that.
Paul
-
I bought the Accutire MS-4021B air gauge for my car and truck because it was highly rated by Consumer Reports. It's a great and accurate gauge but it doesn't work well on my Like 200i's rear tire. Thanks for the advice on the model MS-4710B for motorcycles.
As a side note, I am about ready to order a Genuine Innovations part number G3518 for emergency tire repair inflation with CO2 cylinders. It comes with a repair kit, flexible hose, three 16 g cylinders and a carrying case.