KymcoForum.com
General => General Discussion => Topic started by: Calothrix on May 06, 2010, 03:54:02 AM
-
If you are looking to get some Dr. Pulley sliders (or other scooter stuff for that matter), you might want to check out this seller on Ebay: autotech355
This dude (his name is Carlos, believe it or not!) is out of Taiwan. I purchased my sliders recently from him for $25.00 (free shipping!) and they arrived in only 8 days. He has a good selection of sizes and weights and many of the smaller ones are also only $25.00 with free shipping. He also has an assortment of other scooter stuff: however, I have no idea if it is quality stuff or if the prices are reasonable. Might be worth checking out though. Happy shopping!
-
G'Day Calothrix, I have dealt with Carlos, I bought a cylinder kit from him which is questionable quality, the carb and exhaust were good, his prices are good and he does communicate if you have a problem. I guess what I am saying is beware what you are buying, some may be good and some may not be. With regards with the cylinder kit We have got it going with a lot of help from Shaka and zombie, without these two blokes helping me I would have been lost long ago.
-
autotech355 I knew it was familiar!
-
G'Day Calothrix, I have dealt with Carlos, I bought a cylinder kit from him which is questionable quality, the carb and exhaust were good, his prices are good and he does communicate if you have a problem. I guess what I am saying is beware what you are buying, some may be good and some may not be. With regards with the cylinder kit We have got it going with a lot of help from Shaka and zombie, without these two blokes helping me I would have been lost long ago.
Yo, Sid........yeah I've been following your thread with much anticipation.......I say before you hit page 34, you're gonna have that ZX screamin'.
-
autotech355 I knew it was familiar!
..does he have 4t stuff?...wait.......nevermind...
-
It's funny you say that Calo. (Just gotta nickname) I just figured out what sid's problem is (as far as the scoot is concerned)... Sid! Pm me!!! When you seee what I see you will be popin' wheelies.
-
It's funny you say that Calo. (Just gotta nickname) I just figured out what sid's problem is (as far as the scoot is concerned)... Sid! Pm me!!! When you seee what I see you will be popin' wheelies.
I wanna know!!!!! I'm going with the combustion chamber is too small, thus creating too high of a Compression Ratio resulting in detonation!!!!
-
I am intrigued, unfortunatly I am about to go to work, will pm as soon as I get home and fireup the computer. I havdnt cut the spacer yet, got sidetracked, tomorrow it will be done.
-
I'm going with the combustion chamber is too small, thus creating too high of a Compression Ratio resulting in detonation!!!! The F" up bit is something that I have to say on pm"s! A VERY close review of this thread will show the solution. Your CR is ttooo hi! See you guys in the morning! Just a guess for anyone following would be that sid's CR is over 13.5 w/ a squish of .8mm. That is just an uneducated guess! How do you like it now Jpress? Bet I got your intrest up! The final solution to Sidthesloth's 65mph ZX/Superfever. By tomorrow Sid you will be cruising at 51-54. Tops at 60ish. Wait till you get gears!
-
60, wait till I get gears? frame stiffener first. when I took the head gasket out she went like a shower of sh**, just detonation. my enthusiasm is starting to return, woo~hoo.
-
Foward my Email to Shaka! Boom Boom Chicka Dow wow~