KymcoForum.com
Scooters - 50cc => Agility 50 => Topic started by: wordslinger on April 14, 2010, 05:10:23 PM
-
..just in case any of you guys' starter has quit, i finally got around to investigating what was wrong wih mine...
..since i had one on that junker Marshin I bought, i thought that maybe it would work on my A50..
..the output shaft's were of different length, so I opened my starter to see what i could swap out..
..I found that the two magnets had broken free of the outer casing..
..this was the "squalling, screeching" sound i would here when trying to start...
..so I used the casing from the Marshin, and the armature assembly from mine and i now have my pushbutton start again..
..i'd forgotten how nice that is...lol..
peace
-
You can epoxy the Mags. back in the original case. It's a bitch getting the brushes back in huh!
-
You can epoxy the Mags. back in the original case. It's a bitch getting the brushes back in huh!
....YES IT IS!!!!!....
..and i tHought about the epoxy thing....
..that $20.00 Marshin has payed for itself twice now...lol..
-
It's morphing into an Agility.
-
so now you can start the scoot at first push of the button ? mine one it's starting with buton just when Is already heated ,when engine it's cold I finish the batery and the scoot doesn't start without kick start.
-
so now you can start the scoot at first push of the button ? mine one it's starting with buton just when Is already heated ,when engine it's cold I finish the batery and the scoot doesn't start without kick start.
..try adjusting your idle mix screw....