KymcoForum.com
Scooters - 50cc => Super 9 => Topic started by: Raindrop586 on September 01, 2015, 09:46:08 PM
-
So i got one lol finally a Lc scooter in my hands 8)
question .. were do i get handle bar adapter so i can put down hill bars on ? will aerox fit or ? aprilla ?
question .. Mhr i see only intake .. what size carb to go with ? 19mm or higher ?
so far all malossi i bought . var, bbk,clutch, and some jets for stock carb .
4g rollers .. 2000 springs 2000 torque so far technigas pipe . run stock air box for ow ?
help tips , anything ? Zombie still here ? Shaka ?
-
No clue on the handle bars. Mhr is the only one I've seen also. 4 grams may be too light with the malossi variator. I tried 6.5 gram when I first got mine and it shot the rpms up to 10k. Out of my tecnigas power band. I use the ones that came with it, 9 grams. It keeps me between 8 and 9k.
For the air box, I just used bigger tubing. There's pics here on the forum I think. It acts almost like an open filter without the noise and water issues.
Sent from my VS985 4G using Tapatalk
-
What top speed you get with stock gears ?
I was thinking a 21mm carb with the mhr intake ?
Bummed that this thing dont have options like a Aerox or aprilia
But shes still sick and a LC
-
Pic of her so far .
-
That's a beauty! That looks like the stock front tire, if I remember correctly. Get some nice rubber for that, it'll handle 100 times better. You will need it with the parts you'll be adding.
I'm running the malossi bbk, variator, and clutch, a 19mm arreche carb, lightly bored out my intake, opened up the air box (check out the thread I made), and tecnigas pipe (bought used, model unknown). Running the stock gears, but I may get some malossi that I've seen. Not sure yet how it will perform. I live in the mountains of NC.
I've been unable to properly GPS it since my final set of upgrades, but I was following a coworker and he claims to have been doing sixty, primarily flat surface, wind not in my favor. I get it going on flats and have to back off because it seems like it won't stop climbing in speed and rpms.
Someone caught up to me at a Gas Station one time, said he was doing 55 and I was steadily pulling away. The speedometer barely sees numbers anymore lol.
Most important mod, tire pressure!!
Sent from my VS985 4G using Tapatalk
-
It's a shame there's no front fender. I like the look with it, my opinion...
Sent from my VS985 4G using Tapatalk
-
It's a shame there's no front fender. I like the look with it, my opinion...
Really lol i hate front fender on mopeds lol force of habit to rip off i like the more dirt bike look .
Just waiting on stuff from racing planet . i orderd shock extender to . i might get that polini varaitor. Reviews say its better .
Question ? Are you mixing gas ? Did you put a plug in oil pump ?
And is it stock throttle cable ?
-
I've heard they're similar in performance, malossi was only fifty bucks at the time so I got it.
I bet they would make bitching trail bikes with some dual sport type tires!
I am still rocking it with just the pump but have it adjusted to be a bit more open. Most suggest running premixed after the bbk but I have had no problems. I'm also heard its easier to tune the carb when premixed. I'm considering switching soon myself. Some suggest an ounce added to each fill up with the pump still operational. I only did that during break in. I guess it all depends on how you ride. I usually make sure that if I'm wide open at extra high rpms that if I go to slow down I bump the throttle until the rpms drop to a safer level to keep a bit more oil coming in.
Sent from my VS985 4G using Tapatalk
-
Ya i notced after i jetted carb and plug chops seems running fine
So im not blocking it off till i see burnt plugs . stock oil pump not bad for kymco . my buddys aprilia has a tiny stock carb . kymcos 2 stroke carb is not bad . big for a scoot to.
Ill post more pics when all the goodies come in
-
Yeah, the stock carb is good after jetting to match the air box and pipe setup. I ran with it for quite a while.
I'm looking forward to seeing the pics!
Sent from my VS985 4G using Tapatalk
-
Racing planet takes FOREVER ! >:(
WANT MY PARTS DAMNIT LOL
-
I ordered a water pump rebuild kit from scrappy dogs around the first of August. Still waiting. They have replied to an email a few weeks ago saying that they were going to get it in a week then ship. Oh well, I bought the last shaft in stock from a local dealer to get me by.
Sent from my VS985 4G using Tapatalk
-
Just got to email today saying that shipped out yesterday only took about a month but that's not the half of it at first the order didn't go through so I get to second order in my wife's name and now I have a s*** ton of super 9 Parts coming in both of our names I might just sell the parts on here or another forum cuz the return process on Racing Planet usa pain in the ass
-
So in in a week i will have for sure extra tecnigas trek2 chrome exhaust for super LC9 . ... 175 free ship to whom ever needs it .
-
That would be cool of you. There's times we're in need of things, and I know I hate the hassle of wondering if and when I'm going to get my parts...
Sent from my VS985 4G using Tapatalk
-
8) Exhaust and body lift and transmission parts came in . waiting on intake and carb. 8)
-
Body lift spacer
-
That's looking tough!! I never thought about the spacer. Does it affect handling in any way? Or just cosmetic?
Sent from my VS985 4G using Tapatalk
-
That's looking tough!! I never thought about the spacer. Does it affect handling in any way? Or just cosmetic?
I think it takes bumps in rear waaaaaay better now .
Not gonna lie im 6ft and barley touch ground now lmao
But yea looks evil now
Sent from my VS985 4G using Tapatalk
-
Awesome
Sent from my VS985 4G using Tapatalk