KymcoForum.com

General => Technical | How To => Topic started by: leo.portner on May 06, 2015, 06:34:52 AM

Title: Questions before next DIY project
Post by: leo.portner on May 06, 2015, 06:34:52 AM

I'm thinking to cut and shorten the front windshield on my xciting,
Anyone did this before?
What tool should i use to prevent the plastic from cracking?

Title: Re: Questions before next DIY project
Post by: Chris0381 on May 06, 2015, 01:42:37 PM

You can dremel it but expect some plastic melting and a lot of filing and sanding afterwards.

Plexiglas cutters mainly only cut straight and used for hard plastic laid completely flat.

Title: Re: Questions before next DIY project
Post by: leo.portner on May 06, 2015, 06:45:00 PM

I saw some videos on YouTube where people used a jigsaw with a fine blade and no plastic melted maybe it is better then a Darmel tool...
Any thoughts on how to Tony it black but still keep it clear to see throw?
Tinting film?

Title: Re: Questions before next DIY project
Post by: Chris0381 on May 06, 2015, 09:09:17 PM

I think film would be your best bet.

My windshield is black and I was thinking of etching a design of some sort into the winshield and placing an led light behind it for some fun at night.

Title: Re: Questions before next DIY project
Post by: TLRam1 on May 06, 2015, 09:29:17 PM

Yes, jigsaw, fine tooth blade, masking tape on both sides.