KymcoForum.com

Scooters - 125 to 300 => Downtown 300 => Topic started by: Ahmad Mustafa on September 27, 2014, 10:41:59 PM

Title: please help.
Post by: Ahmad Mustafa on September 27, 2014, 10:41:59 PM

can the Malossi variator adjuster spring(white) be applied to the stock clutch?

Thanks

Title: Re: please help.
Post by: zombie on September 28, 2014, 04:09:40 AM

Yes. That is a lighter than OEM spring however.
If you want to run that one you need very light rollers. That combo usually works well for heavier people.
If you try it w/ OEM rollers you will find a loss of acceleration, and a huge bog when going up hill.
Swap to light rollers, and performance will improve above OEM

Title: Re: please help.
Post by: Ahmad Mustafa on September 28, 2014, 09:19:41 AM

Thanks sir,,
I am using dr. Pulley 14 gm rollers,,, is it  okay?

Title: Re: please help.
Post by: zombie on September 28, 2014, 11:46:19 AM

Is 16 gram the OEM weight?
Did you get slightly more RPM w/ the Dr Pulley? Are they the rollers or Sliders you are using?

If they are the rollers I would go w/ either Malossi purple or red for the spring. If you are over 200 lbs go red.
At or near 200 go w/ the purple.

Title: Re: please help.
Post by: Ahmad Mustafa on October 29, 2014, 03:41:16 PM

The OEM weight is 15.4 gm and yes i got a little higher rpm
I installed both the rollers and the sliders
I am around 180 Lbs
I will  install malossi yellow clutch springs

so what is the best adjuster spring to use?
brand and colour please
thanks

Title: Re: please help.
Post by: zombie on November 19, 2014, 12:48:59 AM

Red or Purple Malossi are what I would use.
OR a set of 14 gram sliders, and the yellow or white Malossi.

Sorry for the long delay.