KymcoForum.com
Scooters - 125 to 300 => Downtown 300 => Topic started by: kneeslider on September 24, 2014, 06:32:00 AM
-
Hello,
My DT's high beam switch when activated, turns off the low beams, unlike the PASS button which allows botht he low and high beams to remain on.
How can I get the high beam switch to activate BOTH the low and high beams?
-
The easiest way would be to modify the switch wiring. Just swap the high beam wire with the pass wire, just look at the wiring diagram on the switch and pin out the two, click the terminals out of the connector and swap.
-
Hello,
My DT's high beam switch when activated, turns off the low beams, unlike the PASS button which allows botht he low and high beams to remain on.
How can I get the high beam switch to activate BOTH the low and high beams?
is there a switch that can replace the passing switch,to be able to turn the high beam on or off as you want ?
-
The easiest way would be to modify the switch wiring. Just swap the high beam wire with the pass wire, just look at the wiring diagram on the switch and pin out the two, click the terminals out of the connector and swap.
i was thinking about this mod too, so I have just had a look at the wiring in the switch, on my dt the wires are soldered, it make job a little more interesting/ difficult!! :) :) :)
i might look into it a bit later.
cheers,
Don.