KymcoForum.com

Offroad => Side By Side => Topic started by: solberglandandcattle on August 28, 2014, 04:15:57 AM

Title: computer
Post by: solberglandandcattle on August 28, 2014, 04:15:57 AM

In my 500i apparently my computer needs to be flashed can this be done by taking it out and sending it to the shop or dots a guy gotta take in the whole unit

Title: Re: computer
Post by: de dee on August 28, 2014, 05:55:18 PM

  I would take the scoot in for a test ride after flashing,  to make sure it was done right,.

Title: Re: computer
Post by: solberglandandcattle on August 29, 2014, 03:45:19 AM

It's a side by side. Now could I just purchase a new cdi and I'll have the power and rpm that I had before or should I take it in and get it flashed or can I just take the computer out and ship it to get flashed, nearest shop is three hours away

Title: Re: computer
Post by: CROSSBOLT on August 29, 2014, 04:04:56 PM

You can "flash"  any EFI computer on ANY vehicle by disconnecting the ground wire from the battery for 30 seconds or longer. Five minutes would make sure. I would guess the Service Manual for that machine probably has a procedure to do the same thing without tools.

Karl

Title: Re: computer
Post by: solberglandandcattle on August 29, 2014, 07:14:20 PM

Ok I tried that and nothing it still is only running at 4000 rpm

Title: Re: computer
Post by: CROSSBOLT on September 05, 2014, 09:09:10 PM

That would tell me the TPS is not set properly and/or the TPS and ISC has not been initialized (maybe). You are stuck with needing access to a service manual at least for a start, and a Kymco EFI analyzer the dealer SHOULD have.

Karl