KymcoForum.com

Scooters - 125 to 300 => Downtown 300 => Topic started by: castle on July 31, 2014, 09:45:03 AM

Title: How to remove the 300i handle bar cover?
Post by: castle on July 31, 2014, 09:45:03 AM

hi,
i want to wire a voltmeter from the handle bar. but i couldn't remove the handle cover after taking out the 4 screws under it. did i miss out somethings?

Title: Re: How to remove the 300i handle bar cover?
Post by: padmovie on July 31, 2014, 11:15:11 AM

No, you don't miss anything, the top cover is hard to take, there are only plastic clips after screws removal,

just more force ... 8)

Title: Re: How to remove the 300i handle bar cover?
Post by: de dee on July 31, 2014, 12:06:50 PM

did you see the two bolts one on each side ,.  and remove the rear view mirrors

Title: Re: How to remove the 300i handle bar cover?
Post by: castle on July 31, 2014, 04:06:12 PM

ok. thanks.

didnt dare to exert too much force. afraid i might break something. will try again.  :)

Title: Re: How to remove the 300i handle bar cover?
Post by: Adept on July 31, 2014, 06:42:48 PM

It is not a rigid plastic. You can use a little force. As I remember (Heated Grip assembly) there are little clips under the plastic...