KymcoForum.com

Scooters - 125 to 300 => Super 8 150 => Topic started by: sunjejin on June 22, 2014, 01:49:15 PM

Title: camshaft timing problem.. helpppp.!!
Post by: sunjejin on June 22, 2014, 01:49:15 PM

does anybody knows how to fix this? when i tried to parallel the two holes in sprocket my timing on flywheel not to center "T" alignment

Title: Re: camshaft timing problem.. helpppp.!!
Post by: DMblues01 on June 22, 2014, 03:27:13 PM

You need to rotate the engine another revolution. the marks on the sprocket should have 3 holes showing. the 2 that line up with the edge of the engine, and 1 straight out in the middle. Then the timing mark should line up as well.

Title: Re: camshaft timing problem.. helpppp.!!
Post by: sunjejin on June 22, 2014, 04:16:14 PM

Quote from: DMblues01 on June 22, 2014, 03:27:13 PM

You need to rotate the engine another revolution. the marks on the sprocket should have 3 holes showing. the 2 that line up with the edge of the engine, and 1 straight out in the middle. Then the timing mark should line up as well.

Thanks for your answer DMblues01 I set my valve clearance in this position, Is there any risk factor can damage my valve?. coz I depend my decision in "T" mark allignment in Flywheel but I think also it should be all set in right timing position, tommorow I set again..

Title: Re: camshaft timing problem.. helpppp.!!
Post by: BettinANDlosing on June 22, 2014, 04:50:55 PM

Yes, the valves are not set correctly if you adjusted then like this. May cruise damage. Don't even look at the flywheel mark. Just make the two can dots level with the head and the large dot facing forward.