KymcoForum.com

Scooters - 50cc => Agility 50 => Topic started by: blue on June 18, 2014, 01:20:05 AM

Title: gas gauge
Post by: blue on June 18, 2014, 01:20:05 AM

Wanting to try to fix gas gauge.does any one know what wires go wear down by the battery.I have one extra hot wire but not sure if thats it.

Title: Re: gas gauge
Post by: zombie on June 18, 2014, 02:09:30 AM

All these bikes have a few extra dead end wires... Most times simply pulling out the sender, and cleaning the metal ring/tank connection fixes it. They work on a resistance to ground, and that mounting ring is the only contact

Title: Re: gas gauge
Post by: blue on June 18, 2014, 02:27:35 AM

I dont think I have it hooked up because I never did after my gy6 swap. I can see yellow green and blue comeing from the tank going in to a plug thats 2 ,green and 1 yellow.from there im not sure.

Title: Re: gas gauge
Post by: zombie on June 18, 2014, 02:31:31 AM

The manual will have it. Why would you have un pluged it?

I can't even look at mine for you. I threw out the harness, and made my own. No gas gauge.

Title: Re: gas gauge
Post by: blue on June 18, 2014, 03:07:56 AM

When I did the swap I was trying to use a gy6 harnes but did not work.so went back to the kymco harnes and stator.

Title: Re: gas gauge
Post by: zombie on June 18, 2014, 05:31:16 AM

Got ya... The harness is broken down in the manual.

If I get a chance today I will run by the shop where the ZX dash is, and see what color is on the gauge.
I'm working out of three different shops, and I have stuff scattered between all of them.

Title: Re: gas gauge
Post by: blue on June 19, 2014, 11:06:55 AM

Ended up takeing gauge out of tank and cleaning it and nothing. So I took the gauge out of tank and run with out.made a plastic cover for the hole.