KymcoForum.com
Scooters - 125 to 300 => People 250 => Topic started by: ispud on September 21, 2009, 03:16:12 PM
-
I poked around a bit in the front plastic to see what the 2 clear lenses are. I am guessing this is where the turn signals go on scooters other than USA models. I have read other posts that talk about restoring the European style turn signals to get rid of the buggy eyed ones on the handlebars. I did not see any wiring going to the built in location, but there was a cast metal housing that looked like it might be part of the European style on the back of the lens - there was a piece of tape over the hole that looks like maybe where a bulb would go. I am guessing if this is the case a person could buy the bulb holder part of this assy and then wire it up and eliminate the bugeyes. Any info on this would be appreciated.
Thanks,
:)>>
-
That's real simple, Just extend your current wireing to the location, and any auto parts shop will have the sockets you need. It is a ticket however if an eagle eyed trooper spots you
-
That's real simple, Just extend your current wireing to the location, and any auto parts shop will have the sockets you need. It is a ticket however if an eagle eyed trooper spots you
..or a tricked out A50...
wooo-woooooo....
-
I notice on the "ugly" p250 the front signals are built into the front plastic panel - this is about where my clear lenses are located. I couldn't find pictures of the ugly p250 where they were supposed to be - someone could post some - no??
:)>>
-
I notice on the "ugly" p250 the front signals are built into the front plastic panel - this is about where my clear lenses are located. I couldn't find pictures of the ugly p250 where they were supposed to be - someone could post some - no??
:)>>
..i think that was jprestonian"s scoot...check his posts...i think the link is in his signature...
peace