KymcoForum.com

General => Technical | How To => Topic started by: CROSSBOLT on May 14, 2014, 03:40:32 PM

Title: TPS and ISC initialization for Yager 200i
Post by: CROSSBOLT on May 14, 2014, 03:40:32 PM

Got ZERO response on Yager section so will try here: What is the procedure? I lost my Yager service manual and I am curious. Anyone care to "weigh in" on this?

Karl

Title: Re: TPS and ISC initialization for Yager 200i
Post by: Stig / Major Tom on May 14, 2014, 05:02:12 PM

Quote from: CROSSBOLT on May 14, 2014, 03:40:32 PM

Got ZERO response on Yager section so will try here: What is the procedure? I lost my Yager service manual and I am curious. Anyone care to "weigh in" on this?

Karl

Please look at my previous post about this. I can only tell you the procedure for the Like200. Will that be of any help? If so, will post when I get home in a few hours.
Stig

Title: Re: TPS and ISC initialization for Yager 200i
Post by: CROSSBOLT on May 17, 2014, 03:38:50 PM

Thanks, Stig. I saw your post on the Like initialization and it read like the service manual only better! What I remember about the Yager I had is a little different than the Like. Don't remember any free end connectors anywhere as on the Like. I would conclude it is one of the key and throttle schemes as on the DT 300i. I lost the Yager service manual since I did not put it on the desktop and just had it bookmarked. Thought maybe one of you real knowledgeable folks just might remember.

Karl