KymcoForum.com

Scooters - 125 to 300 => Downtown 300 => Topic started by: CROSSBOLT on September 18, 2013, 06:01:44 PM

Title: Wolo horn installed on DT300i and Like 200i
Post by: CROSSBOLT on September 18, 2013, 06:01:44 PM

Wolo horns from Harbor Freight are now on the DT and the Like. Wolo supplied a relay for the installation but the toughest part of both was panel removal. Service manual is no help on panel removal.

Karl

Title: Re: Wolo horn installed on DT300i and Like 200i
Post by: de dee on September 19, 2013, 01:06:19 AM

 if you think the front panel was fun wait till you take the sides and taillights off, I found that the two sides and taillight come off together,. in one piece  tail light has 4 nuts two on top and two in back,. the side panels two screws,  one on each side, and 3 tabs to unhook, on each side,.   use vivo,s butter knife looking inside you will see where to push with the butter knife,

Title: Re: Wolo horn installed on DT300i and Like 200i
Post by: de dee on September 19, 2013, 01:09:51 AM

  I dont use a butter knife ,. I got a 1 inch putty knife and rounded the sides so it does not scratch anything,.

Title: Re: Wolo horn installed on DT300i and Like 200i
Post by: CROSSBOLT on September 19, 2013, 09:11:35 PM

Nananananana! I don't wanna know! (fingers in ears/hearing prothetics in standby).

Karl

Title: Re: Wolo horn installed on DT300i and Like 200i
Post by: de dee on September 20, 2013, 12:05:51 AM

resistance is futile!!!

Title: Re: Wolo horn installed on DT300i and Like 200i
Post by: johnson on September 20, 2013, 12:25:51 AM

It could be worse.  You could be trying to take the plastic off a PS250.