KymcoForum.com
Scooters - 125 to 300 => People 250 => Topic started by: Ernst on October 30, 2017, 09:38:55 PM
-
Every time I adjust the valves on my P250S I wish I had the proper tool to hold the adjuster in place instead of needle nose pliers.
I have not sourced the proper valve tool and service manual doesn't give a part number for it. Has anyone found or know where I can get one?
Doh! Ebay!
Okay I ordered a set for $15 8mm,9mm and 10mm
Thanks anyway.. Got post happy.
-
Every time I adjust the valves on my P250S I wish I had the proper tool to hold the adjuster in place instead of needle nose pliers.
I have not sourced the proper valve tool and service manual doesn't give a part number for it. Has anyone found or know where I can get one?
Doh! Ebay!
Okay I ordered a set for $15 8mm,9mm and 10mm
Thanks anyway.. Got post happy.
THE ADJUSTER IS A sqare bolt head just the right size as a # 2 robertson screw driver with the tip removed,
-
i used a square headed screw and bent it to a 90 degree angle i didn't pay anything for it i have a coffee can full of them
-
I got my set and plan to adjust valves tomorrow. I will see if I have the right one.
-
I use the pliers end of my stripper/crimper, never had a problem that I saw the need for a special tool, but I might try the screw idea since it's free.