Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - TonyD

Pages: [1]
1
MXU / Kymco MXU 150
« on: October 10, 2023, 08:09:17 AM »
Hello all, I have an old, 2006 MXU 150. Recently, filling the tank it runs but at say half tank it
begins cutting out. It will restart but the problem persists until the tank is filled again. Any help appreciated.

2
General Discussion / Kymco MXU 150
« on: October 10, 2023, 07:42:00 AM »
Hello all. Recent problem with my MXU 150. I is old now, 2006. Recently I fill the tank and it runs ok. When it gets to say half tank it begins to cut out. I can restart but the problem persists. If I fill the tank it runs ok again.  Assume the MXU 150 is gravity fed? Any ideas. Best wishes. Tony

3
MXU / Still No brakes
« on: March 26, 2019, 04:23:02 PM »
Hi All, thank you to those who contributed to my last post on the same subject. I have installed a new brake caliper on my MXU 150. I also installed new crush washers on both banjo bolts I initially tried to bleed the brakes at the caliper bleed nipple without success. Kymco recommend using a syringe to free the majority of air and then use the normal bleed procedure at the caliper, this I have done until I got clear fluid in the syringe and then went to pumping the brake lever, locking in position and bleed through the caliper bleed screw. I have some pressure in the lever but not enough to apply the new brakes. Can anyone assist. Is it possible the brake disc / rotor needs replacing? Thanks in anticipation.

4
MXU / MXU 150 - No brake lever
« on: March 08, 2019, 02:21:37 PM »
Hi All, just installed a new brake caliper on MXU 150, new brake fluid and bled the system, but the brake lever comes all the way back - no brakes. The fluid is appearing in the tube from the caliper but will not fully discharge into the container. Any ides guys, your help is appreciated. Regards Tony

5
MXU / Brake resevoir screws and brake disc bolts
« on: January 21, 2019, 02:09:08 PM »
Been searching the internet without success for the brake reservoir screws and the brake disc bolts for a 2006 MXU 150. Can anyone help. Regards Tony

6
MXU / MXU 125
« on: October 15, 2014, 09:45:08 AM »
I have recently purchased a used MXU 125 (06) and while on tick over the engine sounds sweet when riding there is what I can only describe as as 'stuttering' sound coming from the front of the bike when accelerating or decelerating (transmission?). Any ideas.

7
Eye Candy | Videos and Pics / ATV MXU 125
« on: October 15, 2014, 09:40:18 AM »
I have recently purchased a used MXU 125 (06). The bike ticks over really sweet but once you are riding there is what I can only describe as a 'stuttering' sound coming from the front of the bike when you accelerate or decelerate. The bike runs ok but this sound (transmission?) can be annoying. Any ideas.

Pages: [1]