Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - forqman

Pages: [1]
1
People s200 / rear handlebar cover on 2008 People S 200
« on: June 30, 2016, 12:56:27 AM »
I cannot get the handlebar cover off to service the headlight and turn signals. I had a post say to give a mighty pull after taking out all 6 screws and bolts which I did but to no avail. I don't want to break the cover and Kynco has not responded to my email request for help. Does anyone have a clue on this?

2
People s200 / slow warm up
« on: June 28, 2016, 09:31:11 PM »
 :( I installed a new carburetor on my 2008 Peoples S 200 and put in a new spark plug. I was hoping  to eliminate the very slow warm up time before the engine could take any throttle. Still have that problem. It seems like an electrical choke issue but since the carb was new I thought that would solve the problem. It did not! Engine will start instantly but won't take throttle for at least 10 minutes of idle time. Any suggestions?

3
Technical | How To / rear handlebar cover on 2008 People S 200
« on: June 04, 2016, 05:00:45 PM »
 ???I installed a new carburetor on my '08 Peoples S 200 and after re-installing the covers and starting up engine the headlight would not come on and right front turn signal has no voltage. I tried to take off the rear handlebar cover and with all tabs unfastened as per repair manual the windshield came off easily but the rear cover would not detach from frame. Any suggestions ?

4
People s200 / new carburetor and headlight goes out
« on: June 04, 2016, 01:41:05 PM »
I replaced the carburetor on my 2008 People S 200 and scooter runs fine but headlight won't come on. Tried to take off rear cover for headlight replacement but could not get it to come off. Any suggestions

Pages: [1]