KymcoForum.com
Scooters - 50cc => Super 9 => Topic started by: chaz35 on January 31, 2016, 06:48:28 PM
-
I am putting on new tires and want to replace the 90 degree angled one on the front wheel. I like the straight better, easier to check the air pressure. Anyway, I know the wheels are made in Italy and the valve stems look smaller OD than what I am used to.
I did a little research and found there are generally 2 sizes 8.3mm and 11.3mm, I am thinking I need 8.3mm. Just checking to see if anyone knows. Cheers
-
I am sure takes 8.3mm or .357", but not easy to find. Anyone know where to get some? Everything I see is too fancy for me, just want straight short rubber pull through, should be approx $1 each.
I guess will install new tires and worry about replacing valve stems later. I guess will check with Kymco next. Cheers
-
Did I just read a full conversation with yourself? :o
-
lol, yes you did, this forum is therapy for me...